Air trapped in the hydraulic fluid of a steering system would be indicated by（）

相似题目

• Which of the following statements describes the functions of a reservoir used in a hydraulic system?（）

  A . Dissipate heat B . Trap foreign matter C . Separate air from the oil D . All of the above

  查看最佳答案

• Which of the following can be used in hydraulic transmission system?（）

  A . Hydraulic oil B . Animal oil C . Light oil D . Fuel oil

  查看最佳答案

• Air trapped in the hydraulic fluid of a steering system may be indicated by（）

  A . the steering pumps overspeeding B . a jammed open relief vale C . a constantly occurring improper rudder response D . excessive ram pressure

  查看最佳答案

• After installing a new hydraulic pump in a system, what special attention should be given to the hydraulic system?（）

  A . The relief valves in the system should be readjusted B . The filters and strainers should be checked frequently C . All system pressure should be readjusted D . The system should be drained and renewed with a fluid of different operating characteristic

  查看最佳答案

• The purging of air from an elector-hydraulic steering gear unit is necessary when（）

  A . changing over to hand pump operation B . engaging the trick wheel C . the system has been filled with new oil D . the rudder angle indicator does not match the helm positio

  查看最佳答案

• Air bubbles in a hydraulic governor can cause （）

  A . sluggish response B . speed droop variations C . isochronous governing D . sensitivity increase

  查看最佳答案

• In a fixed displacement axial piston hydraulic motor, the speed is varied by（）

  A、regulating the ratio between torque and speed via the torque limiter at the motor B、directing the motor output flow through a bypass line C、maintaining a constant flow and pressure input D、controlling the input flow rate

  查看最佳答案

• The function of the hydraulic telemotor transmitter used in an electro-hydraulic steering gear system is to （）.

  A . transmit the rudder angle to the bridge indicator B . prevent the control linkage from striking the stops when hard over C . automatically purge all entrained air from the system D . send hydraulic signals to the receiving unit

  查看最佳答案

• Structural traps are traps（）are formed because of a deformation in the rock layer （）contains the hydrocarbons.

  A . that, that B . what,what C . what,that D . that,what

  查看最佳答案

• The purpose of the compensating adjustment used in a diesel engine hydraulic governor is to （）

  A . compensate for low oil level B . increase governor promptness C . prevent governor hunting D . limit engine load

  查看最佳答案

• Hydraulic control check value is generally used to （） in the marine hydraulic mechanism.

  A . control the back pressure of return oil B . lock the oil lines under some conditions C . change the direction of oil flow D . act as relief valve

  查看最佳答案

• If a hydraulic governor has been refilled with oil, the engine should be operated until it reaches normal temperaturethen the air should be purged, and the（）

  A . rack position should be adjusted B . compensating needle valve should be opened fully compensating C . needle valve should be adjusted to stabilize operation D . speed limiting device should be adjusted

  查看最佳答案

• Hydraulic pumps most commonly used in steering systems are of the （）.

  A . lobe type B . screw type C . axial piston type D . volute type

  查看最佳答案

• The major cause of trouble in a mechanical-hydraulic governor is contamination of the hydraulic fluid by （）

  A . dirt B . fuel oil C . governor cooling water D . fuel oil tar

  查看最佳答案

• The major source of chemical contaminants in hydraulic fluid is （）.

  A . microscopic steel shavings B . abrasive waste C . anti-oxidant compounds D . oxidation by-product

  查看最佳答案

• In an electro-hydraulic steering system, under movement is maintained in close synchronization with the steering wheel position by means of the （）.

  A . trick-wheel B . follow-up control C . six-way valve D . Rapson slide

  查看最佳答案

• The most serious effect of air trapped in a diesel engine jacket water cooling system is that it（）.

  A . causes colloid suspension in the cooling water B . reduces the capability of the lubrication system C . can form pockets which block the flow of coolant through the system D . leads to the scuffing of cylinder wall

  查看最佳答案

• In which of the listed hydraulic systems will the installation of an oil cooler be necessary?（）

  A . Constant tension mooring winch system B . Hatch cover system C . Watertight door system D . Internal combustion engine hydraulic starter system

  查看最佳答案

• In comparison to electric power，hydraulic power for jacking systems has the advantage of（）.

  A . better control capabilities B . less maintenance and repair C . fewer personnel needed during jacking D . less preload needed

  查看最佳答案

• In the design of hydraulic piping and equipment consideration is given to minimize turbulence in the hydraulic fluid, as this will cause （）.

  A . molecular fluid vibration B . energy losses C . wide pressure variations D . mechanical damage to control valve

  查看最佳答案

• Adjustments to the compensating needle valve in a hydraulic governor should be made with the engine at （）

  A . maximum power at a normal load B . maximum power and load under normal conditions C . half speed and normal temperature D . normal operating temperature without a load

  查看最佳答案

• When air becomes trapped in the hydraulic fluid of a steering system, the （）.

  A . rudder will respond sluggishly B . hydraulic rams will over-speed C . sight glass will show bubbles D . ram relief valves will lift

  查看最佳答案

• In the suction stroke air is induced into the cylinder （）In the compression stroke the air is compressed.

  A . by an fuel valve B . through an inlet valve C . with an exhaust valve D . from an outlet valve

  查看最佳答案

• In an electro-hydraulic steering gear, any change in relative position between the synchronous receiver and the follow-up gear will result in（）

  A . the pump going to full stroke B . closing of the six-way valve C . driving the rams up against the stops D . a corresponding slowing or increasing of the pumped flow rate

  查看最佳答案