Jitter is causing problems with the VOIP application in the network. What causes network jitter？（）

相似题目

• Router A is unable to reach Router B.Both routers are running ios version 12.0.After reviewing the command output and graphic,what is the most likely cause of the problem?（）

  A . incorrect bandwidt h configuration B . incorrect LMI configuration C . incorrect map statement D . incorrect IP addre

  查看最佳答案

• （） is sometimes used for piston cooling since leaks into the crankcase would not cause problems.

  A . Diesel oil B . Hydraulic oil C . Lube oil D . Mineral oil

  查看最佳答案

• The doctor said that mental （） is the major cause of his sleeping problem.

  A . tension B . sadness C . anger D . relaxation

  查看最佳答案

• You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN.The phone rings but， when you answer， the call is dropped. What may cause this problem？（）

  A . The minimum data rate is not set to 11 Mbps. B . An address resolution protocol is enabled. C . Publicly Secure Packet forwarding is enabled. D . The access point is set to the least congested channel.

  查看最佳答案

• You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN.The phone rings but， when you answer， the call is dropped. What may have caused this problem？（）

  A . Publicly Secure Packet forwarding is enabled. B . The minimum data rate is not set to 11 Mbps. C . An address resolution protocol is enabled. D . The access point is set to the least congested channel.

  查看最佳答案

• Refer to the exhibit.HostA cannot ping HostB.Assuming routing is properly configured,what could be the cause of this problem?（）

  A . HostA is not on the same subnet as its default gateway B . The address of SwitchA is a subnet address C . The Fa0/0 interface on RouterA is on a subnet that cannot be used D . The serial interfaces of the routers are not on the same subnet E . The Fa0/0 interface on RouterB is using a broadcast addre

  查看最佳答案

• An administrator has mirrored the root volume group to a second disk， but ’bootlist’ is failing to correctly add the second disk.  What is the likely cause of the problem？（）  

  A . The administrator has failed to run ’bosboot -ad <2nd disk>’ prior to the bootlist command. B . The administrator has failed to run ’bootinfo -B <2nd disk>’ prior to the bootlist command. C . The administrator has failed to run ’mirrorvg -m rootvg <2nd disk>’ prior to the bootlist command. D . The administrator has failed to run ’bosboot -ad /dev/ipldevice <2nd disk>’ prior to the bootlist command.

  查看最佳答案

• The Frame Relay network in the diagram is not functioning properly. What is the cause of the problem?（）

  A . The Gallant router has the wrong LMI type configured B . Inverse ARP is providing the wrong PVC information to the Gallant router C . The S3 interface of the Steele router has been configured with the frame-relay encapsulation ietf command D . The frame-relay map statement in the Attalla router for the PVC to Steele is not correct E . The IP address on the serial interface of the Attalla router is configured incorrectly

  查看最佳答案

• An administrator has mirrored the root volume group to a second disk, but 'bootlist' is failing to correctly add the second disk. What is the likely cause of the problem?（）

  A . The administrator has failed to run 'bosboot -ad <2nd disk>' prior to the bootlist command. B . The administrator has failed to run 'bootinfo -B <2nd disk>' prior to the bootlist command. C . The administrator has failed to run 'mirrorvg -m rootvg <2nd disk>' prior to the bootlist command. D . The administrator has failed to run 'bosboot -ad /dev/ipldevice <2nd disk>' prior to the bootlist command.

  查看最佳答案

• You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN. The phonerings but， when you answer， the call is dropped. What may have caused this problem？（）

  A . The minimum data rate is not set to 11 Mbps. B . An address resolution protocol is enabled. C . Publicly Secure Packet forwarding is enabled. D . The access point is set to the least congested channel.

  查看最佳答案

• The major cause of fuel pump and injection system problems is （）

  A . improper adjustments B . contaminated fuel C . kinked fuel lines D . excessive engine vibratio

  查看最佳答案

• Refer to the exhibit.If the devices produced the given output,what is the cause of the EtherChannel problem?（）https://assets.asklib.com/images/image2/2018072411280224790.jpg

  A . There is a speed mismatch between SW1's Fa0/1 and SW2's Fa0/1 interfaces. B . There is an MTU mismatch between SW1's Fa0/1 and SW2's Fa0/1 interfaces. C . There is an encapsulation mismatch between SW1's Fa0/1 and SW2's Fa0/1 interface. D . SW1's Fa0/1 interface is administratively shut down.

  查看最佳答案

• You are troubleshooting a problem with a cisco 7920 wireless ip phone on a standalone wlan. the phone rings but， when you Answer ，the call is dropped. What may have caused this problem？（）

  A . publicly secure packet forwarding is enabled. B . the minimum data rate is not set to 11 mbps. C . an address resolution protocol is enabled. D . the access point is set to the least congested channel.

  查看最佳答案

• Which of the following is not considered a common approach to narrow the field of potential problem causes（）

  A . Following the traffic path B . Top-down C . Comparing configurations D . Bottom-up E . Divide and conquer F . ExamineS LA

  查看最佳答案

• Jitter is causing problems with the VOIP application in the Company network.  What causes  network jitter？（）

  A . Variable queue delays B . Packet drops C . Transmitting too many small packets D . Compressio

  查看最佳答案

• You need to troubleshoot some problems in the Company VOIP network associated with jitter.   What is the cause of jitter？  （）

  A .  Packet drops B .  Transmitting too many small packets C .  Variable queue delays D .  Compression E .  None of the other alternatives apply

  查看最佳答案

• A user has no network connectivity. A check of the associated port indicates that the interface is up，the line protocol is down. Which item would most likely cause this problem？（）

  A . Speed mismatch B . Incorrect encapsulation C . MTU set too low D . Duplex mismatch

  查看最佳答案

• Jitter is an unwanted variation of one or more characteristics of a periodic signal in electronics and telecommunications and（）refers to call issues that cause variations in timing or time of arrival. 

  A .  echo B .  jitter C .  packet loss D .  digitized sampling

  查看最佳答案

• While troubleshooting a routing problem on the company EIGRP network you discover that one ofthe routers is failing to establish adjacencies with its neighbor. What is a likely cause of thisproblem between neighbors？（）

  A . The K-values do not match B . The hold times do not match C . The hello times do not match D . The AS numbers do not match

  查看最佳答案

• https://assets.asklib.com/images/image2/2018072314222285656.jpgWhat is the under lying cause of this problem？（）

  A . A remote physical layer problem exists. B . The host NIC is not functioning. C . TCP/IP has not been correctly installed on the host. D . A local physical layer problem exists.

  查看最佳答案

• If an operating bilge pump is developing good vacuum, but is unable to discharge any water, which of the following problems is the most probable cause?（）

  A . The wearing rings are excessively worn B . The suction strainer is clogged C . The discharge valve is clogged D . The shaft is wor

  查看最佳答案

• Which of the following statements is false about the relationship of causes, problems and effects?

  查看最佳答案

• What is the cause of the problems that people living on parts of the south coast of England face?

  查看最佳答案

• 听力原文： The World Bank says air pollution is one of the worst environmental problems in large cities around the world. Air pollution causes breathing problems. It also threatens crop production in farm areas near huge cities.

  The United Nations Environment Program says that air pollution reduces the amount of crops produced, h also reduces the nutrient level of crops. As a result, both the buyer and the seller of crops are hurt by air pollution. The UN says dirty air is a major source of metal in crops. These metals include lead, zinc and copper. These metals can build up to dangerously high levels in the parts of plants that people eat. The German Appropriate Technology Exchange, GATE, reports that eating these metals can cause developmental problems and low intelligence levels among children. Some kinds of cancers and kidney damage have also been linked to metals in crops. Who is hurt by air pollution？ A．The buyer. B．The seller. C．Both the buyer and the seller. D．None.

  查看最佳答案