Having（）the bear in the woods for one week, the man was almost out of food.

相似题目

• Which term describes piston pins having bearing surfaces in both the piston bosses and connecting rod eye?（）

  A . Stationary B . Full floating C . Semi-floating D . Free rolling

  查看最佳答案

• The lubricating system for the cylinder walls is different from the bearings in that the oil for former one is supplied in （） while that for latter one is （）.

  A . sufficient quantity； measured B . measured quantity；sufficient C . excessive quantity；sufficient D . the less quantity the better；the more the better

  查看最佳答案

• Having been on the（）for the whole month, the criminal decided to turn himself in to the police.

  A . escaped B . caught C . way D . ru

  查看最佳答案

• The oil quantity for bearing lubrication should be applied in such an amount as to be sufficient to carry away the （） caused by the friction at the bearings.

  A . acids B . additives C . heat D . gear

  查看最佳答案

• The results of the audits and reviews （） to the attention of all personnel having responsibility in the area involved.

  A . should bring B . should be brought C . should take D . should be take

  查看最佳答案

• For a main diesel engine the lube oil in the bearings is drawn from （）, usually located in the bedplate.

  A . a gravity tank B . a sump C . a vessel D . a bottle

  查看最佳答案

• The new assembly line having been adopted, the factory produced（）cars in as the year before.

  A . as twice many B . twice many as C . twice as many D . as many as twice

  查看最佳答案

• The bedplate must be rigid enough to support the weight of the rest of the engine, and maintain the crankshaft, which sits in the bearing housings in the （）, in alignment.

  A . longitudinal girders B . transverse girders C . fore girders D . aft girder

  查看最佳答案

• While inspecting the main bearings on a diesel engine you find impregnated dirt and scratches in the bearing surface you would, therefore, suspect that （）

  A . the bearing had been overheated B . water was present in the oil C . the lube oil was not being properly filtered D . the maximum allowable bearing pressure had been exceeded

  查看最佳答案

• In an engine with a pot-shaped piston, some lubricating oil from the main bearing will pass along a drilled passage in the crankshaft to the bottom end bearing and then up a connection rod to the （）.

  A . crosshead B . crankpin C . crank journal D . gudgeon pi

  查看最佳答案

• Which is not the maintenance work for shaft bearings in transmission system?（）

  A . check oil level in bearing sump B . check them for leakagec through end seals C . pump bilges in time D . check temperature

  查看最佳答案

• The design of the connecting rod large end bearing is similar to that of the mainbearings Whats the meaning of "that" in the sentence above?（）

  A . the connecting rod B . large end bearing C . the main bearing D . the desig

  查看最佳答案

• In some modern large diesel engines, which of the following is used as the support for the main bearings?（）

  A . Bedplate B . Block C . Base D . Sum

  查看最佳答案

• In an engine with a pot-shaped piston, some lubricating oil from the main bearing will pass along a （） in the crankshaft to the bottom end bearing andthen up a connection rod to the gudgeon pin.

  A . telescopic pipes B . large bore C . drilled passage D . tied rod

  查看最佳答案

• In most pumps and pump motors overpacking the ball bearings full of grease will result in （）

  A . moisture emulsification of the bearing grease B . insufficient circulation and overheating of the bearing C . proper grease circulation to cool the bearing D . sliding friction between balls and race

  查看最佳答案

• （） clearances in the main or crank pin bearings will sometimes be indicated by loss of pressure in the lubricating system before any bearing knock is heard.

  A . Too larger B . Too smaller C . Excess D . Excessive

  查看最佳答案

• Doors are generally formed in the （） of the both in-line and Vee engines to give maintenance access to the crankshaft main and connecting rod large end bearing.

  A . bedplates B . columns C . cylinder blocks D . safety ca

  查看最佳答案

• In order to improve the working conditions of the crosshead bearings, the bearing pressure is made and the peripheral speed is made in later designs（）

  A . smaller, higher B . higher, smaller C . smaller, smaller D . higher, higher

  查看最佳答案

• The bearing shells depend on the accuracy of （） to held them in a truly circular shape.

  A . the gap B . the clearance C . the bore D . the housing

  查看最佳答案

• Having a lavish funeral became a custom in the Yuan Dynasty.

  查看最佳答案

• In China, according to etiquette practices, when having dinner, the better seats are those facing the main entrance.

  查看最佳答案

• The bear acts as _______ in this film.

  查看最佳答案

• 2. Which of the following is used to monitor the bearing of a radar target in relation to your location?

  查看最佳答案

• "The Matisse bears a kinship of sorts to one of Paul Signac's..." in the last paragraph means

  A．Matisse has a blood relationship with Paul Signac. B．Matisse's work is completely distinct from that of Paul Signac. C．Matisse's work is similar to that of Paul Signac in many aspects. D．Matisse and Paul Signac are descended from the same ancestors.

  查看最佳答案