Router R1 learns two routes with BGP for prefix 200.1.0.0/16. Comparing the two routes, route 1 has a shorter AS_Path Length, smaller MED, the same Weight, and smaller Local PreferencE.Which of the following is true about Router R1‘s choice of best path for this prefix?()
相似题目
-
For a router connected to two ISPs for redundancy, using IPSLA and static routing, how would youconfigure uRPF on the uplink interface?()
-
Policy -Based Routing (PBR) has been enabled on Router R1's interfa ce F0/0. Which of the following is true regarding how PBR works?()
-
Users on the 192.168.1.0/24 network must access files located on the Server 1. What route could be configured on router R1 for file requests to reach the server?()
-
Into which two types of areas would an area border router (ABR) inject a default route?()
-
The network administrator of the Oregon router adds the following command to the router configuration: ip route 192.168.12.0 255.255.255.0 172.16.12.1. What are the results of adding this command (Choose two.)()。
-
Which series of commands will configure router R1 for LAN-to-LAN communication with router R2? The enterprise network address is 192.1.1.0/24 and the routing protocol in use is RIP.()https://assets.asklib.com/images/image2/2018072315342863428.jpg
-
Users on the 192.168.1.0/24 network must access files located on the Server 1. What route could be configured on router R1 for file requests to reach the server()。
-
For a router connected to two ISPs for redundancy, using IPSLA and static routing, how would you configure uRPF on the uplink interface?()
-
A router learns about a remote network from EIGRP, OSPF, and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network()。
-
Router R1 sets a route tag for subnet 10.1.1.0/24 when redistributing from OSPF into EIGRP.Which of the following unit is assigned to the route tag?()
-
The Testking router is running both RIP and IGRP, and the same route is learned by this router from both of these methods. However, when you issue the command"show ip route" you see only the IGRP route, and not the RIP route. Why is this?()
-
hat two things will a router do when running a distance vector routing protocol?()
-
Refer to the above exhibit. Why are the EIGRP neighbors for this router not learning the routes redistributed from OSPF?()https://assets.asklib.com/images/image2/2018073016092178687.jpg
-
Which two steps below should you perform on the hub router while configuring EIGRP routing over DMVPN (mGRE tunnel)? ()
-
Router R1, in ASN 11, learns a BGP route from BGP peer R22 in ASN 22. R1 and then uses BGP to advertise the route to R2, also in ASN 11. What ASNs would you see in the BGP table on R2 for this route?()
-
A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router,as the routing protocol for the network.Which statement about thisnetwork is true?()
-
Router R1 has been conf igured with an ipv6 route 2000::/64 S0/0/0 64 command.Which of the following does the 64 at the end of the command represent?()
-
What two things will a router do when running a distance vector routing protocol?()
-
A router learns about a remote network from EIGRP, OSPF, and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network?()
-
Refer to the exhibit. EIGRP is configured with the default configuration on all routers. Auto summariz ation is enabled on routers R2 and R3, but it is disabled on router R1.Which two EIGRP routes will be seen in the routing table of router R3?()
-
A router has two paths to reach another network in a different autonomous system. Neither route was generated by the local router and both routes have the same default weight an d local preference values.Which statement is true about how BGP would select the best path?()
-
Router R1 exists in an Enterprise that uses EIGRP as its routing protocol. The show ip route command output on router R1 lists the following phrase: "Gateway of last resort is 1.1.1.1 to network 2.0.0.0".Whic h of the following is most likely to have caused this output to occur on R1?()
-
Which two static routes are typically configured on your router when a Routed 1483 network is grouping ATM PVCs intoalarge subnet?()
-
根据网络拓扑和需求说明,完成(或解释)路由器R1的配置。 Router(config) ipv6 unicast-routing(3)