-
Refer to the exhibit. The output that is shown is generated at a switch. Which three of these statements are true? （）
A . All ports will be in a state of discarding, learning, or forwarding.
B . Thirty VLANs have been configured on this switch.
C . The bridge priority is lower than the default value for spanning tree.
D . All interfaces that are shown are on shared media.
E . All designated ports are in a forwarding state.
F . The switch must be the root bridge for all VLANs on this switch.
-
Refer to the exhibit. Given the interface configuration on a DSL connection with PPPoE, select the true statement.（）https://assets.asklib.com/images/image2/201808011449257464.jpg
A . The router is limiting the size of TCP and UDP packets.
B . The configuration implements an effective Layer-2 fragmentation technique.
C . The value of 542 is recommended in several RFCs.
D . There is another upstream router terminating the PPPoE session.
-
Refer to the exhibit.which address and mask combination a summary of the routes learned by EIGRP?（）https://assets.asklib.com/images/image2/2018072408552539657.jpg
A . 192.168.25.0255.255.255.240
B . 192.168.25.16255.255.255.252
C . 192.168.25.0255.255.255.252
D . 192.168.25.28255.255.255.240
E . 192.168.25.16255.255.255.240
-
Refer to the exhibit. Which statement is true about a voice VLAN？（）https://assets.asklib.com/images/image2/2018072610051691343.jpg
A . Physically the voice network and the data network are separate
B . The voice traffic will normally be on a different IP subnet than will the data traffic
C . End user intervention is necessary to place the phone into the proper VLAN
D . The same security policy should be implemented for both voice and data traffic
E . The data VLAN must be configured as the native VLAN
-
Refer to the exhibit. What additional commands should be used to configure OSPF area 5 as a Totally Stubby area? （）https://assets.asklib.com/images/image2/2018073109011650113.png
A . area 0 stub o n routers R4 and R5
B . area 5 stub on routers R4 and R5
C . area 5 stub no - summary on routers R4 and R5
D . area 0 stub no - summary on router R4 and area 5 stub no - summary on router R5
E . area 5 stub no - summary on router R4 and area 5 stub on router R5
-
Refer to the exhibit.
Which protocol establishes an optimal path to the root in a wireless mesh network？ （）
https://assets.asklib.com/images/image2/2018073011454335678.jpg
A . Adaptive Wireless Path （AWP）
B . WLAN Quality of Service （WQoS）
C . Lightweight Access Point Protocol （LWAPP）
D . 802.1Q WLAN trunking protocol
E . Layer 2 Roaming （IAPP）
-
Refer to the exhibit.
What will happen to traffic within VLAN 14 with a source address of 172.16.10.5？（）
https://assets.asklib.com/images/image2/2018073011095486831.jpg
A . The traffic will be forwarded to the router processor for further processing.
B . The traffic will be dropped.
C . The traffic will be forwarded to the TCAM for further processing.
D . The traffic will be forwarded without further processing.
-
Refer to the exhibit.Which three statements correctly describe Network Device A？（）https://assets.asklib.com/images/image2/2018072315413323788.jpg
A . With a network wide mask of 255.255.255.128， each interface does not require an IP address.
B . With a network wide mask of 255.255.255.128， each interface does require an IP address on a unique IP subnet.
C . With a network wide mask of 255.255.255.0， must be a Layer 2 device for the PCs to communicate with each other.
D . With a network wide mask of 255.255.255.0， must be a Layer 3 device for the PCs to communicate with each other.
E . With a network wide mask of 255.255.254.0， each interface does not require an IP address.
-
Refer to the exhibit.
https://assets.asklib.com/images/image2/201807301615135089.png
Which order correctly identifies the steps to provision a cable modem to connect to a headend as defined by the DOCSIS standard？（）
A . A→D→C→G→E→F→B
B . A→D→E→G→C→F→B
C . C→D→F→G→E→A→B
D . C→D→F→G→A→E→B
E . F→D→C→G→A→E→B
-
Refer to the exhibit.Based on the exhibited routing table，how will packets from a host within the192.168.10.192/26 LAN be forwarded to 192.168.10.1？（）https://assets.asklib.com/images/image2/2018072314090474779.jpg
A . The router will forward packets from R3 to R2 to R1
B . The router will forward packets from R3 to R1
C . The router will forward packets from R3 to R1 to R2
D . The router will forward packets from R3 to R2 to R1 AND from R3 to R1
-
Refer to the exhibit a network administrator cannot establish a telnet session with the indicated router at is the cause of this failure?（）https://assets.asklib.com/images/image2/20180724092953904.jpg
A . A .A level 5 password is not set
B . The vty password is missing
C . The console password is missing
D . An ACL is blocking Telnet acce
-
Refer to the exhibit. Which three statements correctly describe Network Device A?（）https://assets.asklib.com/images/image2/2018072316253185664.jpg
A . With a network wide mask of 255.255.255.128, each interface does not require an IP address.
B . With a network wide mask of 255.255.255.128, each interface does require an IP address on a unique IP subnet.
C . With a network wide mask of 255.255.255.0, must be a Layer 2 device for the PCs to communicate with each other.
D . With a network wide mask of 255.255.255.0, must be a Layer 3 device for the PCs to communicate with each other.
E . With a network wide mask of 255.255.254.0, each interface does not require an IP address.
-
Refer to the exhibit. Host A has sent an ARP message to the default gateway IP address10.10.10.1. Which statement is true？（）https://assets.asklib.com/images/image2/2018072614534380870.jpg
A . DSw1 will reply with the MAC address of the next AVF
B . DSw2 will reply with the MAC address of the next AVF
C . Because of the invalid timers that are configured， DSw1 will not reply
D . Because of the invalid timers that are configured， DSw2 will not reply
E . DSw1 will reply with the IP address of the next AVF
F . DSw2 will reply with the IP address of the next AVF
-
Refer to the exhibit. Which statement is true about a voice VLAN？（）https://assets.asklib.com/images/image2/2018072410435948132.jpg
A . Physically the voice network and the data network are separate.
B . The voice traffic will normally be on a different IP subnet than will the data traffic.
C . End user intervention is necessary to place the phone into the proper VLAN.
D . The same security policy should be implemented for both voice and data traffic.
E . The data VLAN must be configured as the native VLAN.
-
Refer to the exhibit. Which two statements are correct regarding the creation of a multicas tdistribution tree？ （）https://assets.asklib.com/images/image2/2018072610011922458.jpg
A . Each router determines where to send the JOIN request.
B . The tree will be built based on the IP address of the E2 interface on router E
C . The best path to the source will be discovered in the unicast routing table on router B
D . The best path to the source will be discovered in the unicast routing table on router C
E . The best path to the source will be discovered in the unicast routing table on router E
-
Refer to the exhibit. A display of class maps for a configuration is shown in the exhibit. What will the class-map "all-traffic" match? （）https://assets.asklib.com/images/image2/2018073114131723118.jpg
A . all voice traffic
B . all traffic with dscp 18 or dscp 43
C . all traffic with dscp 18 and dscp 43
D . all traffic with ip precedence 0 or 1
E . all traffic with ip precedence 4 and 5
-
Refer to the exhibit.
What will happen to traffic within VLAN 14 with a source address of 172.16.10.5？ （）
https://assets.asklib.com/images/image2/2018073011253768356.jpg
A . The traffic will be forwarded to the router processor for further processing.
B . The traffic will be dropped.
C . The traffic will be forwarded to the TCAM for further processing.
D . The traffic will be forwarded without further processing.
-
Refer to the exhibit， which shows a PPPoA diagram and partial SOHO77 configuration.
https://assets.asklib.com/images/image2/201807301549339311.png
Which command needs to be applied to the SOHO77 to complete the configuration？（）
A . encapsulation aal5snap applied to the PVC
B . encapsulation aal5ciscoppp applied to the PVC
C . encapsulation aal5ciscoppp applied to the ATM0 interface
D . encapsulation aal5mux ppp dialer applied to the ATM0 interface
E . encapsulation aal5mux ppp dialer applied to the PVC
-
Refer to the exhibit. Where would a Cisco Unity Express Network Module physically reside? （）https://assets.asklib.com/images/image2/201808011048075306.jpg
A . PC at headquarters
B . PC at the remote office
C . voice-enabled router at headquarters
D . Cisco Unified CallManager publisher at headquarters
E . Cisco Unified CallManager subscriber at headquarters
F . Cisco Unified CallManager Express router at the remote office
-
Refer to the exhibit. The DHCP configuration that is shown is configured on a Cisco router. Whichstatement is true？（）
A . The router will distribute IP addresses from pool 1 until its addresses are exhausted. Then therouter will begin distributing addresses from pool 2
B . The configuration is invalid because the DHCP options are global configuration commands
C . The configuration is incomplete until the DHCP pools are bound to the appropriate interface orinterfaces
D . The router will choose which pool to use based upon the interface the DHCP request wasreceived o
-
Refer to the exhibit.Based on the exhibited routing table,how will packets from a host within the 192.168.10.192/26 LAN be forwarded to 192.168.10.1?（）https://assets.asklib.com/images/image2/2018072408493768982.jpg
A . TherouterwillforwardpacketsfromR3toR2toR1
B . TherouterwillforwardpacketsfromR3toR1
C . TherouterwillforwardpacketsfromR3toR1toR2
D . TherouterwillforwardpacketsfromR3toR2toR1ANDfromR3toR1
-
Refer to the exhibit. According to the routing table, where will the router send a packet destined for 10.1.5.65?（）https://assets.asklib.com/images/image2/2018072408541982136.jpg
A . 10.1.1.2
B . 10.1.2.2
C . 10.1.3.3
D . 10.1.4.4
-
Refer to the exhibit. What additional commands should be used to configure OSPF area 5 as a Totally Stubby area？ （）
<img src='https://img2.soutiyun.com/shangxueba/ask/64290001-64293000/64291910/529008d927b67f31920b5858e5879e0b.png' />
A. area 0 stub o n routers R4 and R5
B. area 5 stub on routers R4 and R5
C. area 5 stub no - summary on routers R4 and R5
D. area 0 stub no - summary on router R4 and area 5 stub no - summary on router R5
E. area 5 stub no - summary on router R4 and area 5 stub on router R5
-
Refer to the exhibit. When running OSPF, What would cause router A not to form an adjacency with router B？（）
<img src='https://img2.soutiyun.com/ask/uploadfile/2019-03-27/67e52e69e1cc511a71a60a5d0c35c68a.jpg' />
A.The loopback addresses are on different subnets
B.The value of the dead timers on the router are different
C.Route summarization is enabled on both routers
D.The process indentifier on router A is different than the process identifier on router B
