When the suspected criminal appeared in court, the judge cast a______look at him.

相似题目

• An administrator trying to restore a backup from tape encounters read errors. The administrator suspects that it could be an issue with the block device. What is the appropriate method to resolve this issue?（）

  A . Set the block size to 0. B . Read the tape using the tctl command. C . Use the 'cpio' command to override tape device settings. D . Run the 'dd' command to identify the block size from the tape.

  查看最佳答案

• While inspecting the main bearings on a diesel engine you find impregnated dirt and scratches in the bearing surface you would, therefore, suspect that （）

  A . the bearing had been overheated B . water was present in the oil C . the lube oil was not being properly filtered D . the maximum allowable bearing pressure had been exceeded

  查看最佳答案

• A document used to indicate suspected cargo damage caused by rough weather would be the （）.

  A . cargo report B . hull damage report C . Master's Note of Protest D . Unseaworthy Certificate

  查看最佳答案

• （）during the voyage any case or suspected case of plague，cholera，yellow fever，smallpox，typhus or relapsing fever?

  A . Has there been B . Have there been C . Has there D . Have there

  查看最佳答案

• If an auxiliary diesel engine temperature is higher than normal ,but the thermostat is determined not to be defective you would suspect a /an （）

  A . cavitation erosion in the water jackets B . excess corrosion inhibitor in the coolant C . dirty jacket water cooler D . defective turbocharger

  查看最佳答案

• If you suspect a diesel engine is misfiring due to air leakage into the fuel system, you should begin looking for the leak at the （）

  A . fuel line connections to cylinder injection valves B . gasket surfaces of the fuel oil filters C . discharge fitting of the fuel injector pumps D . suction side of the fuel oil tra

  查看最佳答案

• An administrator suspects problems on a SCSI hard disk，but upon running diagnostics，no errors were found. What must be done to check the condition of the drive？（）

  A . Run diag and select the ‘Certify Media’ task. B . Perform a read and write test on the disk and monitor errorlog. C . Update the disk firmware to the latest level and monitor errorlog. D . Format the disk to ensure bad blocks are omitted from the disk layout.

  查看最佳答案

• A system administrator suspects that there were problems with the AIX installation on a pSeries server. Which of the following commands can be used， with the appropriate flags， to view the BOS installation output files？（）

  A . alog B . errpt C . lscfg D . install

  查看最佳答案

• If a diesel engine is difficult to start and operates with the engine temperatures lower than normal, you should suspect that the （）.

  A . compression pressures are below normal B . lube oil is diluted with fuel oil C . cranking speed is too low D . exhaust system is partially restricted

  查看最佳答案

• An administrator suspects problems on a SCSI hard disk, but upon running diagnostics, no errors were found. What must be done to check the condition of the drive?（）

  A . Run diag and select the 'Certify Media' task. B . Perform a read and write test on the disk and monitor errorlog. C . Update the disk firmware to the latest level and monitor errorlog. D . Format the disk to ensure bad blocks are omitted from the disk layout.

  查看最佳答案

• A pumproom is suspected of accumulating gases after a ventilation machinery breakdown. Where should the combustible gas indicator case be placed when testing the pumproom atmosphere for combustible gases? （）

  A . In the lower level of the pumproom B . In the middle level of the pumproom C . In the upper level of the pumproom D . On the deck outside the pumproom

  查看最佳答案

• An administrator suspects problems on a SCSI hard disk， but upon running diagnostics， no errors were found. What must be done to check the condition of the drive？（）

  A . Run diag and select the ’Certify Media’ task. B . Perform a read and write test on the disk and monitor errorlog. C . Update the disk firmware to the latest level and monitor errorlog. D . Format the disk to ensure bad blocks are omitted from the disk layout.

  查看最佳答案

• An administrator trying to restore a backup from tape encounters read errors. The administrator suspects that it could be an issue with the block device.  What is the appropriate method to resolve this issue？（）  

  A . Set the block size to 0. B . Read the tape using the tctl command. C . Use the ’cpio’ command to override tape device settings. D . Run the ’dd’ command to identify the block size from the tape.

  查看最佳答案

• The police questioned some suspects, but they all denied any _____ in last night's murder.

  查看最佳答案

• She suspected the children were up to some ____ and she found them in the garden digging up the flowers.

  查看最佳答案

• If you suspect that the illness might be serious, you should not ________ going to the doctor.

  查看最佳答案

• One witness ______that he'd seen the suspect run out of the bank after it had been robbed.

  A．convicted B．retorted C．conformed D．testified

  查看最佳答案

• I'd like to remind you that there is no_____on the part of suspects to answer questions.

  A. obligation B.evidence C.transaction D.motivation

  查看最佳答案

• — Who do you suspect _____ having stolen the wallet? — Hard to say. A withB forC aboutD of

  查看最佳答案

• The officer compelledthe suspect to wait at the scene of the crime（)。A.allowed

  B.witnessed C.forced D.required

  查看最佳答案

• Inappropriate attire for an interview make the interviewer suspect that you do not have good judgment as to what the right behavior. should be in a formal setting.

  A．Right B．Wrong C．Not mentioned

  查看最佳答案

• The police（)Mr. Burger’for the wanted suspect and informed the headquarters immediate

  The police()Mr. Burger’for the wanted suspect and informed the headquarters immediately. A、treated B、took C、believed D、recognized.

  查看最佳答案

• I'd like to remind you that there is no _____ on the part of suspects to answer qu

  A．A.transaction B．B.obligation C．C.motivation D．D.evidence

  查看最佳答案

• An administrator trying to restore a backup from tape encounters read errors. The administrator suspects that it could be an issue with the block device.What is the appropriate method to resolve this issue？（）

  A.Set the block size to 0. B.Read the tape using the tctl command. C.Use the ‘cpio‘ command to override tape device settings. D.Run the ‘dd‘ command to identify the block size from the tape.

  查看最佳答案