-
Which two QoS classification and marking statements are true？（）
A . In a Frame Relay network， delay sensitive traffic is tagged with the discard eligible （DE） bit.
B . In an MPLS network， the three most significant bits of the DSCP or the IP precedence of the IP packet are copied into the MPLS EXP field
C . In an MPLS network， the MPLS EXP bits are used to identify up to 16 CoS values.
D . The differentiated services code point （DSCP） field consists of the first three bits of the IP precedence field in the header of an IP packet.
E . The 802.10 standard uses a three bitfield referred to as the user priority bits （PRI） to mark packets as belonging to a specific CoS.
-
Which two statements about the QoS policy generation phase of the Cisco SDM QoS wizard are true？ （）
A . The SDM QoS wizard will create two real-time traffic classes to handle VoIP and voice signaling packets.
B . The SDM QoS wizard will create three real-time traffic classes to handle VoIP， voice signaling， and video packets.
C . The SDM QoS wizard will create four real-time traffic classes to handle VoIP， voice signaling， video， and video streaming packets.
D . The SDM QoS wizard will create two business-critical traffic classes to handle transactional and network management packets.
E . The SDM QoS wizard will create three business-critical traffic classes to handle transactional， network management， and routing packets.
F . The SDM QoS wizard will create four business-critical traffic classes to handle transactional， network management， routing， and best-effort packets.
-
Which two statements or sets of statements are true about the application of the qos pre-classify command？（）
A . If the classification policy is based upon the ToS byte， the qos pre-classify command is required because the ToS byte only appears in the inner IP header.
B . The ToS byte is copied to the outer header by default. Therefore， the qos pre-classify command is not necessary.
C . With GRE encapsulation， the qos pre-classify command is applied on the tunnel interface. This practice allows for different OoS configurations on each tunnel.
D . With GRE encapsulation， the qos pre-classify command is applied on the physical interface. This practice allows for different OoS configurations on each interface.
E . With IPsec encapsulation， the qos pre-classify command is applied on the physical interface. This practice allows for different OoS configurations on each interface.
-
Which two QoS classification and marking statements are true？ （）
A . In a Frame Relay network， delay sensitive traffic is tagged with the discard eligible （DE） bit.
B . In an MPLS network， the three most significant bits of the DSCP or the IP precedence of the IP packet are copied into the MPLS EXP field.
C . In an MPLS network， the MPLS EXP bits are used to identify up to 16 CoS values.
D . The differentiated services code point （DSCP） field consists of the first three bits of the IP precedence field in the header of an IP packet.
E . The 802.1Q standard uses a three bit field referred to as the user priority bits （PRI） to mark packets as belonging to a specific CoS.
-
Which two statements about the QoS functionality of the Cisco SDM are true？（）
A . the first step when using the SDM QoS wizard is to select the inbound interface on which the QoS policy must be applied
B . the SDM QoS wizard can be used to optimize LAN， WAN， and VPN interfaces
C . he SDM QoS wizard supports network-based application recognition （NBAR） to provide deep and stateful packet inspection
D . he SDM QoS wizard will apply custom queuing and priority queuing policies to the identified interfaces
E . he SDM QoS wizard will apply low latency-queuing，custom-queuing and priority-queuing policies to the identified interfaces
F . to create and manage the QoS settings， the user must select the QoS wizard task under the Monitor optio
-
Which statement is NOT a key QoS recommended requirement for voice bearer traffic?（）
A . Voice traffic should be marked to DSCP EF per the QoS baseline and RFC3246.
B . Voice traffic loss should be no more than 3%.
C . One-way latency （mouth-to-ear） should be less than 150 msec.
D . Average one way jitter should be targeted to less than 30 msec.
E . 21-320 Kbps of guaranteed priority bandwidth is required per call depending on sample rate，codec，and layer 2 overhead.
-
Which two statements are true about RSVP and the InServ QoS model？（）
A . a drawback of implementing RSVP is the requirement to migrate to a supporting routing protocol
B . RSVP uses DSCP to signal QoS requirements to routers
C . RSVP is a routing protocol
D . RSVP is an IP protocol that uses IP protocol ID 46， and TCP/UDP ports 3455
E . RSVP specifically provides a level of service for rate-sensitive and delay-sensitive traffic
F . the flow-based approach of RSVP is ideal for large， scalable implementations such as the public internet
-
Which two statements about the QoS policy generation phase of the Cisco SDM QoS wizard are true？（）
A . the SDM QoS wizard will create two real-time traffic classes to handle VoIP， voice signaling， and video packets
B . the SDM QoS wizard will create three real-time traffic classes to handle VoIP， voice signaling， video， and video packets
C . the SDM QoS wizard will create four real-time traffic classes to handle VoIP， voice signaling， video， and video streaming packets
D . the SDM QoS wizard will create two business-critical traffic classes to handle transactional and network management packets
E . the SDM QoS wizard will create three business-critical traffic classes to handle transactional， network management， and routing packets
F . the SDM QoS wizard will create four business-critical traffic classes to handle transactional， network management， routing， and best-effort packet
-
Which two statements are true about the implementation of QoS？ （）
A . Implementing DiffServ involves the configuration of RSVP.
B . Implementing IntServ allows QoS to be performed by configuring only the ingress and egress devices.
C . Implementing IntServ involves the utilization of RSVP.
D . Traffic should be classified and marked by the core network devices.
E . Traffic should be classified and marked as close to the edge of the network as possible.
-
Which two statements about QoS options in a Cisco UCS environment are true？（）
A . The QoS policy assigns a system class to the outgoing traffic for a vNIC or vHBA.
B . Flow-control policies determine whether the uplink Ethernet ports in a Cisco UCS environment send and receive IEEE 802.3x pause frames when the send buffer for a port fills.
C . If no system class is configured as CoS 0， the Fibre Channel system class is used.
D . The user can configure QoS for these system classes： platinum， gold， silver， best effort， Fibre Channel.
E . When configuring a system class， the type of adapter in a server may limit the maximum MTU supported.
-
Which two QoS statements are true about the use of the SDMQoS wizard？（）
A . business-critical traffic includes VoIP and voice signaling packets
B . SDM can be used to configure a basic QoS policy for incoming traffic on WAN interfaces andIPsec tunnels
C . SDM can provide QoS for real-time traffic and business-critical traffic
D . SDM creates a custom-queuing （CQ） or a priority-queuing （PQ） policy
E . SDM creates a low latency queuing （LLQ） service policy with its associated classes
F . when allocating bandwidth， values can be entered in either bandwidth percentage or kilobytes per second （kBps）
-
Which two statements complete a transaction?（）
A . DELETE employees;
B . DESCRIBE employees;
C . ROLLBACK TO SAVEPOINT C;
D . GRANT SELECT ON employees TO SCOTT;
E . ALTER TABLE employees SET UNUSED COLUMN sal;
F . Select MAX(sal) FROM employees WHERE department_id = 20
-
Which two statements about the DiffServ QoS model are true？（）
A . DiffServ requires RSVP to set up a path through the network to accommodate the requested QoS.
B . Network traffic is identified by class， and the level of service is chosen for each class.
C . The DiffServ model relies on a fairly simple mechanism to provide QoS over a wide range of equipment.
D . RSVP enables the DiffServ model to provide end-to-end QoS.
E . The DiffServ model is more scalable than the IntServ model.
F . The flow-based approach of the DiffServ model is ideal for large scalable implementations such as the public Internet.
-
Which two statements correctly describe a Cisco WLC configuration of Wireless > QoS > Profiles >Wired_QoS_Profiles for an implementation of DSCP or CoS deployment?（）
A . It must always be set on all QoS profile types because this sets the type of markings as either CoS or DSCP.
B . It is optional if the Cisco WLC attached switch operates on a trust DSCP model.
C . It must be set if the Cisco WLC attached switch operates on a trust CoS model.
D . It sets the EDCF queue used for the radio-transmitted frames.
-
Which two statements correctly identify considerations to take into account when deciding on Campus QoS Design elements?（）
A . Voice needs to be assigned to the hardware priority queue.
B . Voice needs to be assigned to the software priority queue.
C . Call signaling must have guaranteed bandwidth service.
D . Strict-priority queuing should be limited to 50 percent of the capacity of the link.
E . At least 33 percent of the link bandwidth should be reserved for default best-effort class.
-
Which two statements are true about the implementation of QoS？（）
A . Implementing DiffServ involves the configuration of RSVP.
B . Implementing IntServ allows QoS to be performed by configuring only the ingress and egress devices.
C . Implementing IntServ involves the utilization of RSVP.
D . Traffic should be classified and marked by the core network devices.
E . Traffic should be classified and marked as close to the edge of the network as possible.
-
Which two statements correctly identify considerations to take into account when deciding onCampus QoS Design elements？ （）
A . Voice needs to be assigned to the hardware priority queue
B . Voice needs to be assigned to the software priority queue
C . Call signaling must have guaranteed bandwidth service
D . Strict-priority queuing should be limited to 50 percent of the capacity of the link
E . At least 33 percent or the link bandwidth should be reserved tor default best effort cla
-
When you decide on Campus QoS Design elements, which two statements correctly identify considerations to be taken into account?（）
A . Voice needs to be assigned to the hardware priority queue.
B . Voice needs to be assigned to the software priority queue.
C . Call signaling must have guaranteed bandwidth service.
D . Strict-priority queuing should be limited to 50 percent of the capacity of the link.
-
Which two statements about the implementation of WLAN QoS are true？（）
A . The 802.11e standard is the IEEE 802.11 OoS WLAN standard.
B . The Wi-Fi Multimedia （WMM） standard decreases the eight priority levels to four access categories.
C . The Wi-Fi Multimedia （WMM） standard is a Wi-Fi Alliance standard that increases the four priority levels to eight access categories.
D . The Wi-Fi Multimedia （WMM） standard is an IEEE standard that increases the four priority levels to eight access categories.
E . Wireless 802.11 deploys Distributed Coordination Function （DCF）， carrier sense multiple access with collision detection （CSMA/CD）， interframe spacing， and random wait timers to avoid collisions.
F . Wireless OoS designs and implementations commonly use Layer 3 differentiated services code point （DSCP） or Layer 2 802.1 p to ensure priority
-
Which two statements are true about the application of QoS in a converged network？（）
A . end-to-end network delay times that exceed 50 ms for real-time traffic are considered unacceptable
B . end-to-end network delay times that exceed 250 ms for real-time traffic are considered unacceptable
C . end-to-end network delay is not a factor as long as the delay is consistent
D . some packet loss can be corrected by codec algorithms
E . RSVP handles voice packet retransmission
F . fragmentation is a result of packet lo
-
Which two statements correctly identify factors to consider when Configuring WAN QoS？（）
A . Voice Traffic uses Assured Forwarding
B . Voice Signaling traffic uses Assured Forwarding
C . Voice Signaling traffic uses priority queuing
D . Voice Traffic uses priority queuing
E . Voice signaling traffic should use priority queuing with Assured Forwarding
-
Which two statements about the best effort model for QoS are true？（）
A . delay sensitive packets are given preferential treatment
B . the default policy identifies a delay sensitive class and default class
C . the default policy identifies a delay sensitive class， best effort class， and default class
D . the model is highly scalable
E . the model is still predominant on the internet F the model provides guaranteed service
-
Which two statements are true about the various methods of implementing QoS？（）
A . Cisco AutoQoS can be used repeatedly to apply a single QoS policy to multiple interfaces.
B . Cisco AutoQoS includes an optional web-based GUI for automating the configuration of QoS services.
C . Cisco AutoQoS provides capabilities to automate VoIP deployments.
D . The auto qos global configuration command is used to configure Cisco AutoQoS.
E . The Modular QoS CLI （MQC） is the best way to fine tune QoS configurations.
F . The SDM QoS wizard is the fastest way to implement QoS.
-
Which two QoS statements are true about the use of the SDM QoS wizard？（）
A . Business-critical traffic includes VoIP and voice signaling packets.
B . SDM can be used to configure a basic QoS policy for incoming traffic on WAN interfaces and IPsec tunnels.
C . SDM can provide QoS for real-time traffic and business-critical traffic.
D . SDM creates a custom-queuing （CQ） or a priority-queuing （PQ） policy.
E . SDM creates a low latency queuing （LLQ） service policy with its associated classes.
F . When allocating bandwidth， values can be entered in either bandwidth percentage or kilobytes per second （kBps）.
