Refer to the exibit .An attempt to deny web access to a subnet blocks all traffic from the subnet.Which interface command immedicately removes the effect of ACL 102?（）https://assets.asklib.com/images/image2/2018072409460628004.jpg

相似题目

• Refer to the exhibit. What is the configuration an example of？ （） https://assets.asklib.com/images/image2/2018073015220049716.jpg

  A .  GLBP weighting B .  default AVF and AVG configuration C .  GLBP MD5 authentication D .  GLBP text authentication E .  GLBP timer manipulatio

  查看最佳答案

• Refer to the exhibit. The output that is shown is generated at a switch. Which three of these statements are true? （）

  A . All ports will be in a state of discarding, learning, or forwarding. B . Thirty VLANs have been configured on this switch. C . The bridge priority is lower than the default value for spanning tree. D . All interfaces that are shown are on shared media. E . All designated ports are in a forwarding state. F . The switch must be the root bridge for all VLANs on this switch.

  查看最佳答案

• Refer to the exhibit. When deploying an MSFC and an FWSM, which statement is correct?（）https://assets.asklib.com/images/image2/2018072609055419681.jpg

  A . Proper placement depends on the VLAN assignment. B . Place it outside the firewall. C . Place it inside the firewall to make design and management easier. D . Place it inside the firewall with multiple context modes connecting to all configured contexts.

  查看最佳答案

• Refer to the exhibit. https://assets.asklib.com/images/image2/2018073016070377463.png Which three statements describe the steps that are required to configure an IPsec site-to-site VPN using a GRE tunnel？（）

  A . The command access-list 110 permit gre must be configured to specify which traffic will be encrypted. B . The command access-list 110 permit ip must be configured to specify which hosts can use the tunnel. C . The tunnel destination 172.17.63.18 command must be configured on the Tunnel0 interface. D . The tunnel mode gre command must be configured on the Tunnel0 interface. E . The tunnel source Ethernet1 command must be configured on the Tunnel0 interface. F . The tunnel source Tunnel0 command must be configured on the Tunnel0 interface.

  查看最佳答案

• Refer to the exhibit. Looking at the topology diagram and the partial router configurations shown, which statement is true? （）https://assets.asklib.com/images/image2/2018073016254049258.jpg

  A . The NProuter has two OSPF neighbors in the "Full" adjacency state B . The NProuter serial0/0 interface has the OSPF dead timer set to 10 seconds C . The NProuter serial0/0 interface has been configured with an OSPF network type of "pointtopoint" D . The 10.1.1.1 and 10.1.1.2 routers are not using the default OSPF dead and hello timers setting E . The "Mismatched" error is caus ed by the expiration of the OSPF timer

  查看最佳答案

• Refer to the exhibit. Which configuration would correctly enable Host A to acquire an IP address from the DHCP server that is located at 10.1.2.10/24? （）https://assets.asklib.com/images/image2/201807301525026565.jpg

  A . ASw1(config)# interface range FastEthernet 0/1 - 24 ASw1(config - if - range)# ip forward - protocol udp 67 ASw1(config - if - range)# ip forward - protocol udp 68 B . ASw1(config)# interface range FastEthernet 0/1 - 24 ASw1(config - if - range)# ip helper - address 10.1.2.10 C . RTA(config)# interface fastethernet0/0 RTA(config -if)# ip forward- protocol udp 67 RTA(config - if)# ip forwar d- protocol udp 68 D . RTA(config)# interface fastethernet0/1 RTA(config -if)# ip forward- protocol udp 67 RTA(config -if)# ip forward- protocol udp 68 E . RTA(config)# interface fastethernet0/0 RTA(config - if)# ip helper - address 10.1.2.10 F . RTA(config)# in terface fastethernet0/1 RTA(config - if)# ip helper - address 10.1.2.10

  查看最佳答案

• Refer to the exhibit. Look at the command output. What would be the most probable reason for this port-ID mismatch？（）https://assets.asklib.com/images/image2/2018072409172527062.jpg

  A . spanning-tree misconfiguration B . speed mismatch configuration C . cabling problem D . configuration problem

  查看最佳答案

• Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?（）https://assets.asklib.com/images/image2/2018072409560147847.jpg

  A . data link layer B . application layer C . access layer D . session layer E . network layer

  查看最佳答案

• Refer to the exhibit. Which protocol establishes an optimal path to the root in a wireless mesh  network？ （） https://assets.asklib.com/images/image2/2018073011454335678.jpg

  A .  Adaptive Wireless Path （AWP） B .  WLAN Quality of Service （WQoS） C .  Lightweight Access Point Protocol （LWAPP） D .  802.1Q WLAN trunking protocol E .  Layer 2 Roaming （IAPP）

  查看最佳答案

• Refer to the exibit. Three cisco 2950 switches are set to their default priority settings.During the spanning-tree process，which switch will be elected as the root bridge？（）https://assets.asklib.com/images/image2/2018072314082137678.jpg

  A . Switch3 B . Switch4 C . Switch2 D . Switch1

  查看最佳答案

• Refer to the exhibit. https://assets.asklib.com/images/image2/2018072608430379107.jpg Which of the following is an advantage of device clustering utilizing Virtual Port Channels （vPC）？（）

  A .  A logical star topology provides a loop free environment so that all links will be used forwardtraffic B .  Enhanced EtherChannel hashing load balancing using the vPC peer link internal to the VPC C .  The control plane functions of the Nexus switches are merged to hide the use of virtualization D .  Neighboring devices connect on a Layer 3 MEC for improved packet forwarding

  查看最佳答案

• Refer to the exhibit. How will interface FastEthernnet0/1 respond when an 802.1x-enabled client  connects to the port？  （） https://assets.asklib.com/images/image2/2018073011005317862.jpg

  A .  The switch will uniquely authorize the client by using the client MAC address. B .  The switch will cause the port to remain in the unauthorized state， ignoring all attempts by the  client to authenticate. C .  The switch port will disable 802.1x port-based authentication and cause the port to transition to  the authorized state without any further authentication exchange. D .  The switch port will enable 802.1x port-based authentication and begin relaying authentication  messages between the client and the authentication server.

  查看最佳答案

• Refer to the exhibit. What is the configuration an example of？（）

  A . enabling modular QoS over Frame Relay B . enabling Real-Time Transport Protocol （RTP） header compression C . enabling distributed compressed Transmission Control Protocol D . enabling latency and jitter reduction for Transmission Control traffic E . enabling TCP header compressio

  查看最佳答案

• During an abandonment or drill，the first person to arrive at the survival craft should（）.

  A . pass out food and water to personnel B . open the doors and start the sprinkler system C . activate the emergency release handle D . open the doors and prepare the craft for boarding

  查看最佳答案

• Refer to the exhibit. At the end of an RSTP election process, which access layer switch port will assume the discarding role?（）https://assets.asklib.com/images/image2/2018072317314615527.jpg

  A . Switch3, port fa0/1 B . Switch3, port fa0/12 C . Switch4, port fa0/11 D . Switch4, port fa0/2 E . Switch3, port Gi0/1 F . Switch3, port Gi0/2

  查看最佳答案

• Refer to the exhibit. Host A has sent an ARP message to the default gateway IP address10.10.10.1. Which statement is true？（）https://assets.asklib.com/images/image2/2018072614534380870.jpg

  A . DSw1 will reply with the MAC address of the next AVF B . DSw2 will reply with the MAC address of the next AVF C . Because of the invalid timers that are configured， DSw1 will not reply D . Because of the invalid timers that are configured， DSw2 will not reply E . DSw1 will reply with the IP address of the next AVF F . DSw2 will reply with the IP address of the next AVF

  查看最佳答案

• Refer to the exhibit. Look at the command output. What can you use to prevent this behavior？ （）https://assets.asklib.com/images/image2/2018072317480043501.jpg

  A .  UDLD  （UniDirectional Link Detection） B .  spanning-tree loopguard C .  VTP mode transparent D .  switchport mode desirable

  查看最佳答案

• Refer to the exhibit. Look at the command output. What would be the most probable reason for this port-ID mismatch？（）https://assets.asklib.com/images/image2/2018072317451781682.jpg

  A .  spanning-tree misconfiguration B .  speed mismatch configuration C .  cabling problem D .  configuration problem

  查看最佳答案

• 8. In the sentence “…population are being added to at both ends,” the words “both ends” refer to both __________.

  查看最佳答案

• An old bus ground to a halt at the bus stop.

  查看最佳答案

• The term “boy” is potentially insulting if you use it to refer to an  (    ) male.

  查看最佳答案

• The term “boy” is potentially insulting if you use it to refer to an ( ) male.

  查看最佳答案

• It takes Ruby an hour to go to classes at the college everyday.

  A．Right. B．Wrong. C．Doesn't Say.

  查看最佳答案

• Refer to the exhibit. When running OSPF, What would cause router A not to form an adjacency with router B？（）

  <img src='https://img2.soutiyun.com/ask/uploadfile/2019-03-27/67e52e69e1cc511a71a60a5d0c35c68a.jpg' /> A.The loopback addresses are on different subnets B.The value of the dead timers on the router are different C.Route summarization is enabled on both routers D.The process indentifier on router A is different than the process identifier on router B

  查看最佳答案