-
Lubricating oil systems are fitted with a wide variety of strainers some of which can be cleaned in site while others have replaceable cartridgesThe bold and italic word “which” means （）.
A . lubricating oil
B . lubricating oil systems
C . strainers
D . cartridge
-
In ships where the engine room is designed as UMS, temperature sensors are fitted at critical points within the scavenge spacesActivation would cause automatic （）of the engine.
A . stop
B . start
C . speed up
D . slow dow
-
Although the parties are entitled to make their contract in any manner that they like，it is usual for them to adopt one of the standard forms and then（）it as they think fit.
A . amend
B . repair
C . improve
D . clear
-
The fittings used to secure a watertight door are known as（）.
A . clamps
B . clasps
C . dogs
D . latche
-
The antennas of the trucks on deck are not fitted（）.
A . in
B . on
C . out
D . with
-
Safety shackles are fitted with（）.
A . a threaded bolt
B . a round pin，with a cotter pin
C . a threaded bolt，locknuts，and cotter pins
D . round pins and locknut
-
Fuel oil tank vents are fitted with a screen which will stop（）.
A . oil from flowing out of the tank vent
B . air from entering the tank vent
C . vapors from leaving the tank vent
D . flames on deck from entering the tank vent
-
Air chambers are usually fitted to reciprocating pumps in order to （）.
A . increase discharge pressure
B . increase suction vacuum
C . develop pulsation flow
D . keep a steady rate of flow
-
Frapping lines are fitted to lifeboat davits to（）.
A . secure the lifeboat in the davits when in the stowed position
B . bring the lifeboat close along the rail in the embarkation position
C . give the occupants a safety line when the boat is being lowered from the embarkation level
D . reduce the swinging of the lifeboat at the embarkation level
-
Cast iron and gunmetal fittings are used freely in small sizes at moderate pressure; large fittings, those for high pressure and temperature are cast or mild steelIn the above sentence, the word “those” means （）.
A . east iron firings
B . mild steel fittings
C . small fittings
D . large fitting
-
The Vessel’s cargo holds are properly fitted with（）in way of hatches.
A . Floor-ceiling
B . Battens
C . Covers
D . Hard-wood board
-
According to the regulations，to prevent excessive pressure buildup in cargo tanks containing LFG，they are fitted with（）.
A . pressure vacuum relief valves
B . excess flow valves
C . safety relief valves
D . flame scree
-
Some diesel engines are fitted with a thermometer in the cooling water outlet from each cylinderIf the cooling water temperature from all cylinders begins to rise above normal, you should suspect （）
A . increase blow-by in all cylinders
B . incomplete combustion in all cylinder
C . overloading in all cylinders
D . insufficient fuel delivery to all cylinder
-
Most hydraulic steering gears are fitted with relief valves which（）
A . function when the rudder is amidships
B . relieve excess whip pressure from the hydraulic oil system
C . protect the piping assembly from external rudder shock
D . relieve excessive telemotor pressure
-
Bilge keels are fitted on ship to（）.
A . assist in drydock alignment
B . improve the vessel's stability
C . protect the vessel from slamming against piers
D . reduce the rolling of the vessel
-
In Poland, rules are not to be scared, they can often be bent, or made to fit different situations.
-
When employees fit in with the corporate culture, they are more likely to enjoy their time in the workplace.
-
In English, there are some natural words that naturally fit with other words and make them sound more natural._________
-
More and more people are aware of the importance of fitness.
-
Employees who fit in with the corporate culture are likely to be less productive.
-
Battens are fitted in cargo holds across the frames of the vessel from the turn of the bilge Upward.The purpose of these cargo battens is ______.
A.for securing a snatch block when snaking cargo into the wings of the hold
B.to prevent cargo from coming in contact with the vessel’s frames or shell plating
C.to provide fittings to which cargo lashings may be secured
D.to support the dunnage floors which are laid down between tiers of cargo
-
In order to prevent stress from being set up in the metal, expansion joints are fitted which ________ the stress by allowing the pipe to expand or contra ct freely.
A) relieve
B) reconcile
C) reclaim
D) rectify
-
？Read the text below about presentation tips.&8226;In most or the lines 34 -45, there is one extra word. It is either grammatically incorrect or does not fit in with the meaning of the text. Some lines, however, are correct.
？If a line is correct, write CORRECT on your Answer Sheet.
？If there is an extra word in the line, write the extra word in CAPITAL LETTERS on your Answer Sheet.
Know the needs of' your audience. Put what you have to say in a logical sequence. Ensure your speech will be captivating up to
34 your audience as well as worth their time and attention. Practice
35 and rehearse of your speech at home or where you can be at ease
36 and comfortable, in the front of a mirror, your family, friends or
37 your colleagues. Use a tape-recorder and listen to yourself. Videotape
38 your presentation and analyze on it. Know what your strong and
39 weak points are. Emphasize your strong points during your presentation.
40 When you are presenting it in front of an audience, you are performing
41 as an actor is on stage. How much you are being perceived is very
42 important. Dress appropriately for the occasion, Be solemn if your
43 topic is serious. Present the desired image to your audience. Speak
44 slowly, enunciate clearly, and show off appropriate emotion and feeling
45 relating to your topic subject. Vary the tone of your voice and dramatize if necessary.
(34)
-
Merchant and passenger ships are generally required to have a life preserver for every person aboard and in many cases, a certain percentage of smaller sizes for children.According to United States requirements, life preservers must design, reversible capable of being quickly adjusted to fit the uninitiated individual, and must be so designed as to support the wearer in the water in an upright or slightly backward position.
Sufficient buoyancy （浮力）to support the wearer should be retained by the life preserver after 48 hours in the water, and it should be reliable even after long period of storage.Thus it should be made of materials resistant to sunlight, gasoline, and oils, and it should be not easily set on fire.The position in which the life preserver will support a person who jumps or falls into the water is most important, as is its tendency to turn the wearer in the water from a face-down position to an upright or slightly backward position, with his face clear of the water, even when the wearer is exhausted or unconscious.
The method of adjustment to the body should be simple, and self-evident to uninitiated persons even in the dark under the confused conditions, which follow a disaster.Thus, the life preserver should be reversible that it is nearly impossible to get it on wrong.Catches, straps, and ties should be kept to a minimum.In addition, the life preserver must be adjustable to the wide variety of shapes and sizes of wearers, since this greatly affects the position of floating and the self-righting qualities.A suitable life preserver should also be comfortable to wear at all times, in and out of the water, not so heavy as to encourage to take it off on shipboard while the ship is in danger, nor so burdensome that it hinders a person in the water while trying to swim.
1.The passage is mainly about（）.
A.the uses of life preservers
B.the design of life preservers
C.the materials for life preservers
D.the buoyancy of life preservers
2.According to the passage, a life preserver should be first of all （）.
A.adjustableB.comfortableC.self-evidentD.self-righting
3.United States Coast Guard does NOT require the life preserver to be made （）.
A.with as few strings as possible
B.capable of being worn on both sides
C.according to each wearer's size
D.comfortable and light to wear
4.By “the uninitiated individual” （Para）1, Line.4.the author refers to the person （）.
A.who has not been instructed how to use a life preserver
B.who has a little experience in using a life preserver
C.who uses a life preserver without permission
D.who becomes nervous before a disaster
5.What would happen if a person were supported by the life preserver in a wrong position？
A.The waves would move him backwards.
B.The water would choke him.
C.He would immediately sink to the bottom.
D.He would be exhausted or unconscious.
