When reassembling the bowl of a disk-type centrifuge, the bowl or locking ring is rotated （）.

相似题目

• Clean oil is achieved in a clarifier bowl where the impurities and water collect at the bowl （）.

  A . bottom B . top C . center D . periphery

  查看最佳答案

• Which factor determines the ring dam size for a fuel oil, tubular bowl type, centrifugal purifier?（）

  A、The viscosity off the fuel B、The quantity of water to be removed from the fuel C、The specific gravity of the fuel . D、The quantity of dirt to be removed from the fuel

  查看最佳答案

• For a L√Opurifier, if the back pressure of the oil outlet is too high, the interface between oil and water in the bowl will （）.

  A . be interrupted B . move downwards C . move outwards D . retain original positio

  查看最佳答案

• When deploying IPCC Express 4.0 for the first time, when and where is the licensing of the customer specified? （）

  A . during Installation Cluster Setup, in the CRS Installer   B . after installation, during first-time login, in CRS Application Administration   C . after installation, in CRS License Update Utility   D . during Installation Server Setup, in the CRS Installer

  查看最佳答案

• The interface between the liquid seal (water) and the oil should be positioned （） possible to the bowl periphery.

  A . as far as B . as soon as C . as close as D . as closer a

  查看最佳答案

• When a clarifier is running the impurities and water collect at the bowl （）.

  A . center B . periphery C . inlet D . upper part

  查看最佳答案

• When crossing the magnetic equator the（）.

  A . Flinders bar should be inverted B . Heeling magnet should be inverted C . The quadrantal spheres should be rotated 180° D . Flinders bar should be moved to the opposite side of the binnacle

  查看最佳答案

• Ordinarily the transit（）when the goods leaves the seller’s possession，and ends when they get into the possession of the buyer.

  A . begins B . ends C . finishes D . complete

  查看最佳答案

• When a boiler is operating, the water level in the gauge glass reads （） when the boiler is shut down.

  A . lower than B . higher than C . as much as D . the same a

  查看最佳答案

• When starting an engine, the compressed air enters the cylinder when the corresponding piston is in position of its（）

  A . suction stroke B . compression stroke C . power stroke D . exhaust stroke

  查看最佳答案

• During the dock repair, each sea valve must be disassembled, cleaned and ground well.Before it reassemble the sealing surface between the valve and the valve seat should be checked by （）

  A . chief engineer B . surveyor C . the engineer D . the technique personnel of the shipyard

  查看最佳答案

• When the（）is large, the ship is stiff; and when it is small, she is tender.

  A . GM B . free surface C . longitudinal center of gravity D . transverse center of gravity

  查看最佳答案

• Before reassembling any machinery, you should （）.

  A . replace all bearings regardless of length of service B . apply a heavy coat of oil to all mating surfaces C . clean any corroded surfaces and file all burrs smooth D . coat all parts with alemite grease

  查看最佳答案

• To center a compass bowl in its binnacle，you should have the ship on an even keel，heading north or south，and adjust the screws until（）.

  A . the compass heading is in line with the lubber's line B . there is no lost motion in the gimbal rings C . no change of heading by compass is observed if you raise and lower the heeling magnet D . the gimbal rings do not strike the compass frame when they are tilted

  查看最佳答案

• “A centrifuge consists of an electric motor driving a vertical shaft on the top of which is mounted the bowl assembly”.According to this sentence, we can know that is mounted on the top of the vertical shaft（）

  A . a centrifuge B . an electric motor C . a bowl assembly D . a driving motor

  查看最佳答案

• A centrifuge of which the bowl is arranged as the upper and lower parts separate discharges the sludge（）

  A . by opening the separator manually B . by separating the lower part from the upper part automatically C . by separating the upper part from the lower part automatically D . continuously

  查看最佳答案

• Which of the following problems will occur if a disk-type centrifugal lube oil purifier is not properly primed prior to admitting oil flow to the bowl?（）

  A、Contamination of the lube oil by emulsification will result B、The lube oil will not be subjected to the proper centrifugal force C、The lube oil will overheat and flash D、Oil will discharge from the heavy phase discharge port and be wasted.

  查看最佳答案

• Putting salt in the sugar bowl for the next person is ___________.

  查看最佳答案

• 7 When does the referee give the other team a free kick?A When a player commits a foul.B When the ball goes out of the sides of the pitch.C When the ball leaves the ends of the pitch.

  查看最佳答案

• The Super Bowl is usually held ().

  查看最佳答案

• Because the recordings are destined to be chopped up and reassembled as needed , a speech sound recorded one day may wind up next to another archived a week later.

  查看最佳答案

• There is _____ soup in the bowl.

  查看最佳答案

• For a L.Opurifier, if the back pressure of the oil outlet is too high, the interface between oil and water in the bowl will _____.

  A.be interrupted B.move downwards C.move outwards D.retain original position

  查看最佳答案

• During the dock repair, each sea valve must be disassembled, cleaned and ground wellBefore it reassemble the sealing surface between the valve and the valve seat should be checked by ____.

  A.chief engineer B.surveyor C.the engineer D.the technique personnel of the shipyard

  查看最佳答案