ZXCTN equipment software version's mismatch with T3 EMS version may cause EMS to

相似题目

• U31网管上配置PTN业务时，下列哪项是需要在ZXCTN6300/6200上配置而不需要在ZXCTN6100上配置（）

  A . VLAN接口配置 B . UNI配置 C . 静态MAC配置 D . ARP配置

  查看最佳答案

• 中兴ZXCTN设备在U31网管上对网元进行基础配置的操作过程中，下列哪项在ZXCTN6100上不需进行配置（）

  A . 静态MAC配置 B . 永久ARP配置 C . IP接口 D . VLAN接口

  查看最佳答案

• T3网管上配置PTN业务时，下列哪项是需要在ZXCTN9004/9008上配置而不需要在ZXCTN6100上配置（）.

  A . VLAN接口配置 B . UNI配置 C . 静态MAC配置 D . ARP配置

  查看最佳答案

• ZXCTN 6100开局过程中，在端口配置监控时必须要比ZXCTN6200/6300/9000多一句配置，请问是以下哪一句（）

  A . switchport mode trunk B . mcc-vlan bandwidth 100 C . mcc-vlanid xxxx（xxxx为端口的监控VLAN） D . switchport mode acce

  查看最佳答案

• 26. In March, the company is going toA. install new computer software.B. start using new computer software.C. test the new computer software.

  查看最佳答案

• Software document is an important part of software and a basis of software development phase. It also influnces software's(72).

  A．Expansibility B．Reusability C．Portability D．Maintenance

  查看最佳答案

• On ZXCTN equipment, time synchronization SSM and synchronization Ethernet SSM run ind

  是 否

  查看最佳答案

• Which of the following boards does R4ASB on ZXCTN equipment stand for？（)

  A．A.n4 ports Enhanced Gigabit Ethernet Combo interface B．B.n4 ports Channelized POS STM-1 Board C．C.n4 ports Channelized STM-1 Board D．D.n4 ports ATM STM-1 Board

  查看最佳答案

• Steps for local upgrade of ZXCTN6100: enter boot mode and type （), and equipment vers

  Steps for local upgrade of ZXCTN6100: enter boot mode and type (), and equipment version will be PUT to memory RAM of 6100.

  查看最佳答案

• 专用传输系统ZXCTN6500-16L、ZXCTN6500-8设备的重要单板如主控板、交换板、电源等都采用冗余热备份配置。（)

  是 否

  查看最佳答案

• When creating tunnel for ZXCTN equipment on T3 EMS, incoming and outgoing labels of t

  是 否

  查看最佳答案

• On T3 EMS, the granularity of performance collection for ZXCTN equipment can be（)and（

  On T3 EMS, the granularity of performance collection for ZXCTN equipment can be()and().

  查看最佳答案

• QoS configuration modes that ZXCTN equipment currently supports include:（)。

  A．A.nPort ACL B．B.nTMP rate limit C．C.nPW rate limit D．D.nport rate limit

  查看最佳答案

• Which of the following on ZXCTN equipment has the highest APS priority？（)

  A．A.nlock protectio B．B.nsf-p protection channel signal failure C．C.nfs forced switching D．D.nsf signal failure

  查看最佳答案

• When configuring pseudo wire for E1 service on ZXCTN equipment, make sure （)and contro

  When configuring pseudo wire for E1 service on ZXCTN equipment, make sure ()and control field must be selected.

  查看最佳答案

• Software engineering economy is an effective part of software engineering，which ofthe following contents is the research content of software engineering economy( )．

  ①estimation of software development cost ③earn & cost analysis of software development ③adjustment of software development progress A．①only B．②and③ C．①and② D．all

  查看最佳答案

• Software Engineering Economy is an effective part of software engineering, which of the following content is the research comtent of software engineering economy？

  Ⅰ.Estimation of software development cost Ⅱ.Earn & Cost analysis of software development Ⅲ.Adjustment of software development progress A．Ⅲ only B．Ⅱ and Ⅲ C．Ⅰ and Ⅱ D．all

  查看最佳答案

• About monitoring IP of ZXCTN equipment, which of the following are correct？（)

  A．A.For ZXCTN6100 equipment of Version 1.0, monitoring IP of EMS is LOOPBACK1 of the equipment B．B.For ZXCTN6100 equipment of Version 1.1, monitoring IP of EMS is LOOPBACK1 of the equipment C．C.For ZXCTN6200/6300 equipment, monitoring IP of EMS is interface IP of the equipment D．D.For ZXCTN6200/6300 equipment, monitoring IP of EMS is LOOPBACK IP of the equipment

  查看最佳答案

• BOOT upgrade on ZXCTN equipment requires entry to（)mode of equipment for executing upg

  BOOT upgrade on ZXCTN equipment requires entry to()mode of equipment for executing upgrade command.

  查看最佳答案

• During the check and accept testing for the ZXCTN equipment, the delay is an important

  A．A.100% B．B.90% C．C.80% D．D.70%

  查看最佳答案

• Termination loopback in software loopback of PTN equipment means signal loopback to i

  是 否

  查看最佳答案

• The 1+1 hot backup functional board supported by the ZXCTN 6300/6200 equipment include

  A．A.Cross-connect clock main control board B．B.GE optical interface board C．C.XGE optical interface board D．D.FE electrical interface board

  查看最佳答案

• Which of the following boards are not supported by the ZXCTN 6100 equipment？ （)

  A．A.E1 board B．B.Channelized STM-1 board C．C.4-port GE board D．D.4-port FE board

  查看最佳答案

• System software controls computer hardware and loads software into （）

  A．RAM B．ROM C．Website

  查看最佳答案