The cylinder covers and the liners are bolted together by means of studs () the cylinder frames.
![](/upload/20220827/c85071da6ff0aadc10ebce6c25bb4f0d.png)
相似题目
-
The cylinder liner forming the cylinder wall and the inside of the water jacket is called a()
-
When the air charge contacts with the cylinders and pistons and mixes with the residual gases, it will()
-
In some type of two-stroke engines, besides some small holes for(), starting valve, safety valve, indicator cock, and central opening in each cylinder cover for mounting the()
-
In an engine with air inlet valve and exhaust valve on its cylinder heads the fresh air will enter into the cylinder () and the gases exhaust (), there being an adequate overlap between the inlet opening and the exhaust closing.
-
Cold clearances between the skirt of an aluminum piston and the cylinder liner is about ()
-
The cylinder cover is not provided with ().
-
Fresh water is used for the cooling of cylinder jackets and () of the marine diesel engine.
-
An efficient seal between the cylinder block and cylinder heads on many diesel engines is obtained with()
-
The cylinder head, cylinder liner and () form the combustion chamber.
-
Cracks in cylinder and cylinder covers may () from unequal heating.
-
In addition to lubricating, cylinder oil assists in forming a gas seal and contains () which clean the cylinder liner.
-
The space between cylinder liner and jacket is called ().
-
The cooling water jacket is common to all the cylinders but there are often () to ensure that each cylinder receives the right amount and flow of water.
-
Once a scavenge fire is detected, fuel should be shut off from the affected cylinders and cylinder lubrication increased () the risk of seizure.
-
A-frames are mounted on the bed plate and support () and cylinder block.
-
Oil is supplied to the cylinder wall and () by means of mechanical lubricators.
-
There is a () system lubricating the running gear and cooling the piston and sometimes lubricating the cylinders.
-
The cylinder covers and the liners are bolted together by means of ().
-
() power is the power developed within the cylinder and can be measured by an engine indicator.
-
The cylinder covers are secured by eight elastic holding down arranged in four pairs()
-
The () chamber is enclosed between the cylinder head and piston.
-
The major difference between CIF and CFR is that under CIF, the seller is required to cover the()
-
The very north and south regions are covered with ice and snow.
-
The difference between the covered and uncovered interest parity conditions is()
推荐题目
- 直接驱动离心泵转子泵的电动机,国内常用的同步转速一般为()。
- 斜巷运输用的钢丝绳连接装置,在每次更换钢丝绳时,必须用()倍于其最大静荷重的拉力进行试验。
- 展览场馆的整体结构从平面结构上可分为()。
- 按照实用化验收要求,输电检修综合报告与工作票的关联率要达到100%。
- 下列各项中,不属于年金的为()。
- 沉淀的溶解度是指在一定()下,一定量的溶剂中能够溶解物质的最高量。
- 2岁女孩,因吃奶差、腹胀、便秘近2年来诊,此患儿出生后不久即表现喂养困难、吃奶差、少哭、少动、腹胀、便秘、哭声嘶哑,近2~3个月出现面部、眼睑水肿。至今不会说话、不会走路。查体;体温35.7℃,心率66次/min,呼吸22次/min,皮肤粗糙,毛发干枯,表情呆滞,声音嘶哑,眼距宽,鼻根低平,舌伸出口外,面部眼睑水肿,双肺听诊无啰音,心音低钝,腹膨隆,有脐疝,四肢肌张力弱。最可能的诊断()
- 台湾居民凭《暂住证》原件和复印件,作为过户交易的身份证件。()
- 平行研究与影响研究的主要区别:
- 一般来说,工程的细部放样精度要求往往低于整体放样精度。()