When oily water separator is operating, which measure () is wrong.
相似题目
-
Oil water separators are used to ensure that ships don’t discharge oil when () bilge water.
-
In an oily water separator the oil will travel () to the oil collecting spaces.
-
The pump used to send the bilge water into the oily water separator()the mixture because this might create finer oil particles.
-
()are used to ensure that ships don’t discharge oil when pumping out oily water from any oil contaminated space.
-
What’s the advantage of oily water separator that meets the requirement of MEPC 60(33) over MEPC 107(49)?()
-
The pressure difference of the gauge on the oily water separator increases greatly, the reason is()
-
The principle of separation by which all commercially available oily water separators function is () differential between oil and water.
-
The ()is fitted on an oily water separator.
-
The resistance to the movement of the globule in oily water mixture depends on its size and the () of the fluid.
-
Which of the following pumps will most affect oily water separator performance and give the worst result?()
-
Which of the following pumps is most suitable for an oily water separator?()
-
The operating water is supplied under the ()of an oil separator.
-
When oily ballast has been pumped overboard,an entry must be made in the().
-
某散货船总吨位10050,于2007年7月建造,设计机舱含油舱底水系统时,设计人员向审图工程师咨询关于滤油设备(油水分离器,oily bilge water separator)的几个问题,在参照MARPOL附则I第14条后,审图工程师通知设计人员以下的理解是正确的()
-
Oily water separator mis-alarms, the most possible reason is ()
-
Before the oily water separator put into operation, it should be ()
-
The remaining oil/water mixture now flows down into the fine separating compartment and moves slowly between the() in the Turbulo separator.
-
Before the oily water is installed on board ships, it must have ()
-
Which of the following liquids can ordinarily be discharged overboard without being processed through an oily water separator?()
-
When separating the lube oil without additive, it is usually cleaned with hot water; the aim is to remove () from it.
-
()can not cause oil flow from water outlet of self-cleaning separator.
-
Which of the following is wrong about operation of oily water separator?()
-
To assist separation of low viscosity oils steam coils or electric heaters are fitted () of the oily water separator.
-
The remaining oil/water mixture now flows down into the fine separating compartment and moves slowly between the_____ in the Turbulo separator.