AGBLK must be set to a non-zero value （that is = 1 in Ericsson’s GSM system), if:（)

相似题目

• A non-return valve in the air delivery line near to the compressor must be （）type similar to the compressor discharge valve.

  A、the low inertia B、the high inertia C、the low velocity D、the high velocity

  查看最佳答案

• A system must be evaluated and tuned.  In order to use a set of performance evaluation programs （e.g. filemon， svmon， and tprof）， which of the following packages should exist on the system？（）

  A .  bos.rte.control （WLM） B .  bos.perf C .  xlC.rte D .  perfagent.tool

  查看最佳答案

• When assigning a standalone access point a non-root role， which two parameters， other than role in the radio network settings， must be configured on the ssid manager page？（）

  A . force infrastructure devices to associate only to this ssid B . set infrastructure ssid C . multiple bssid D . set data beacon rate E . enable ip redirection on this ssid

  查看最佳答案

• The clutch band of a constant tensioning mooring winch must be set up tight enough to drive the winch drum and should slip only when （）.

  A . excessive loads are placed on the winch B . minimum pull is being exerted by the winch C . automatic operation of the winch is desired D . wire is being retrieved at the maximum rate

  查看最佳答案

• A cluster administrator is trying to configure tmssa for the non-IP network. Having installed the devices.ssa.tm.rte fileset， what is the next step that must be performed to create the target mode devices？（）  

  A .  Reboot each cluster node. B .  Change the ssa node number to a non-zero value. C .  Change the SSAR device state from defined to available. D .  Run the cfgmgr process on each node to create the target mode devices.

  查看最佳答案

• A JSP page needs to set the property of a given JavaBean to a value that is calculated with the JSP page. Which three jsp：setProperty attributes must be used to perform this initialization？（）

  A . Id B . Val C . Name D . Param E . Value F . Property

  查看最佳答案

• When optimizing a standalone point-to-multipoint bridge installation with eight non-root bridges，which of the following RTS threshold and CWmin settings would be correct for the non-root bridges？（）

  A . RTS threshold = 1，CWmin = 4 B . RTS threshold = 4000，CWmin = 5 C . RTS threshold = 4000，CWmin = 3 D . RTS threshold = 1，CWmin = 5

  查看最佳答案

• In order to allow the establishment of a Telnet session with a router, which set of commands must be configured?（）https://assets.asklib.com/images/image2/201807231503035435.jpg

  A . A B . B C . C D . D E . E F . F

  查看最佳答案

• Given two different character sets (A and B), which of the following must be true for A to be considered a strict superset of B?（）

  A . A must contain all of the characters defined in B B . A must be Unicode C . The encoded values in A must match the encoded values in B for all characters defined in B D . A must be a multibyte character set E . The encoded values in A must match the encoded values in B for all numeric and alphabetic characters in B

  查看最佳答案

• For NIM to install client machines located in a non-adjacent network， which routing must be defined？（）  

  A . Boot/install servers will be required on each intermediate network. B . When an install is initiated by the client， routing is only required from the LPAR back to the NIM master. C . When an install is initiated by the NIM master， routing is only required from the NIM master to the client. D . Appropriate network NIM resources need to be defined to the NIM master to allow routing in both directions.

  查看最佳答案

• When setting an access point to a non-root role， what two parameters，other than Role in theRadio Network，must be configured on the SSID Manager page？（）

  A . Infrastructure devices to associate only to this SSID B . Enable IP redirection on this SSID C . Set Data Beacon Rate D . Multiple Basic Service Set Identification （BSSID） E . Set infrastructure SSID

  查看最佳答案

• When setting an access point to a non-root role，what two parameters，other than role in the radio network， must be configured on the ssid manager page？（）

  A . infrastructure devices to associate only to this ssid B . enable ip redirection on this ssid C . set data beacon rate D . multiple basic service set identification （bssid） E . set infrastructure ssid

  查看最佳答案

• When setting up a modem， which of the following files MUST be edited in order to configure it？（）

  A . /etc/rc.tcpip B . /etc/uucp/Devices C . /etc/rc.net D . /etc/uucp/Dialcode

  查看最佳答案

• When optimizing a standalone point-to-multipoint bridge installation with eight non-root bridges Which of the following rts threshold and cwmin settings would be correct for the non-root bridges？（）

  A . rts threshold = 1，cwmin = 4 B . rts threshold = 4000，cwmin = 5 C . rts threshold = 4000，cwmin = 3 D . rts threshold = 1，cwmin = 5

  查看最佳答案

• When assigning a standalone access point a non-root role， which two parameters， other than Rolein the radio network settings， must be configured on the SSID Manager page？（）

  A . Force Infrastructure Devices to associate only to this SSID B . Set Infrastructure SSID C . Multiple BSSID D . Set Data Beacon Rate E . Enable IP redirection on this SSID

  查看最佳答案

• You work as a network engineer at TestKing.com. You are required to allow establishment of a Telnet session with a router TestKingC.Which set command must be configured?（）

  A .https://assets.asklib.com/images/image2/2018072717510448028.jpg B .https://assets.asklib.com/images/image2/2018072717511289780.jpg C .https://assets.asklib.com/images/image2/2018072717511936039.jpg D .https://assets.asklib.com/images/image2/2018072717512431070.jpg E .https://assets.asklib.com/images/image2/2018072717513262336.jpg F .https://assets.asklib.com/images/image2/201807271751385786.jpg

  查看最佳答案

• In order to allow the establishment of a Telnet session with a router, which set of commands must be configured（）。https://assets.asklib.com/images/image2/2018072310404858564.jpg

  A . A B . B C . C D . D E . E F . F

  查看最佳答案

• When assigning a standalone access point a non-root role， which two parameters， other than Rolein the radio network settings，must be configured on the SSID Manager page？（） 

  A . Force Infrastructure Devices to associate only to this SSID B . Set Infrastructure SSID C . Multiple BSSID D . Set Data Beacon Rate E . Enable IP redirection on this SSID

  查看最佳答案

• When assigning a standalone access point a non-root role， which two parameters， other than Role in theradio network settings，must be configured on the SSID Manager page？（）

  A . Set Data Beacon Rate B . Set Infrastructure SSID C . Enable IP redirection on this SSID D . Multiple BSSID E . Force Infrastructure Devices to associate only to this SSID

  查看最佳答案

• When optimizing a standalone point-to-multipoint bridge installation with eight non-root bridges. Which of the following rts threshold and cwmin settings would be correct for the non-root bridges？（）

  A . rts threshold=4000，cwmin=3 B . rts threshold=1，cwmin=4 C . rts threshold=4000，cwmin=5 D . rts threshold=1，cwmin=5

  查看最佳答案

• The Cluster Administrator wants to use disk heartbeats as a non-IP network. What Volume Group consideration must be accounted for prior to configuring disk heartbeats？（）  

  A .  The Volume Group major number must be the same on all nodes. B .  The Shared Volume Group must be created with the Big VG format. C .  The Volume Group must be created as Enhanced Concurrent Capable. D .  The "t factor" must be doubled to create the reserved area for disk hearbeats.

  查看最佳答案

• Given two different character sets （A and B）， which of the following must be true for A to be considered a strict superset of B？（）

  A .  A must contain all of the characters defined in B B .  A must be Unicode C .  The encoded values in A must match the encoded values in B for all characters defined in B  D .  A must be a multibyte character set E .  The encoded values in A must match the encoded values in B for all numeric and alphabetic character

  查看最佳答案

• Usually， the AWB is non-negotiable， the goods must be sent to the（）titled inthe air waybill.

  A．consignor B．shipper C．carrier′s agent D．consignee

  查看最佳答案

• Usually, the AWB is non-negotiable, the goods must be sent to the（)titled in the air waybi

  Usually, the AWB is non-negotiable, the goods must be sent to the()titled in the air waybill. A．consignor B．consignee C．carrier D．notify party

  查看最佳答案