Worn main bearings in a diesel engine can result in ()
相似题目
-
The main bearings are provided with thin-walled (), lined with a copper-lead alloy.
-
For a main diesel engine the lube oil in the bearings is drawn from (), usually located in the bedplate.
-
Because of the close tolerances used in diesel engine fuel oil pumps, a worn plunger requires()
-
While inspecting the main bearings on a diesel engine you find impregnated dirt and scratches in the bearing surface you would, therefore, suspect that ()
-
In a four-stroke/cycle diesel engine, badly worn intake valve guides can cause excessive().
-
The main bearing shells are made of steel with a lining of bearing metal which may be white metal, copper-lead or aluminum-tin alloy What is the meaning of “which” in the sentence above?()
-
In an engine with a pot-shaped piston, some lubricating oil from the main bearing will pass along a drilled passage in the crankshaft to the bottom end bearing and then up a connection rod to the ().
-
Worn main bearing will cause the compression ratio of an auxiliary diesel engine to()
-
In a diesel engine, blow-by is generally the result of worn()
-
Diesel engine main and connecting rod precision bearings are made in halvesEach half exceeds one-half the bearing circumference by a small amountThe small amount is termed ().
-
The main bearing metal is a lining ().
-
On a large low-speed main propulsion diesel engine, lower main bearing wear is usually measured by using a/an ()
-
In some modern large diesel engines, which of the following is used as the support for the main bearings?()
-
Proper lubrication of the main bearing is more easily obtained in a single acting four-stroke/cycle diesel engine than in a single acting two-stroke/cycle diesel engine because ()
-
Proper lubrication of the main bearings is more easily obtained in a single acting, four-stroke/cycle diesel engine than in a tow-stroke/cycle diesel engine because().
-
In an engine with a pot-shaped piston, some lubricating oil from the main bearing will pass along a () in the crankshaft to the bottom end bearing andthen up a connection rod to the gudgeon pin.
-
In motor-ships, (), after passing through main and motion bearings and oil cooled pistons, etcis either retained in the bedplate.
-
() clearances in the main or crank pin bearings will sometimes be indicated by loss of pressure in the lubricating system before any bearing knock is heard.
-
Doors are generally formed in the () of the both in-line and Vee engines to give maintenance access to the crankshaft main and connecting rod large end bearing.
-
A main bearing consists of two shells which are secured by means of studs and ().
-
The external circumference of a pair of main bearing shells is slightly () that of the bore of the housing which receives them Whats the meaning of “that” in the sentence above?
-
What are the two main recurring symbols in “A Worn Path”?
-
What does the hunter in “A Worn Path” drop?
-
North American fur trade ______ in the early 1800' s mainly due to the diminishing number of fur-bearing animals.