-
Which two routing protocols support MPLS traffic engineering link information distribution? ()
A . OSPF
B . BGP
C . RIP version 2
D . IS-IS
E . EIGRP
-
Which routing protocol supports a flexible area structure using routing levels one and two?()
A . OSPF
B . EIGRP
C . IS-IS
D . BGP
-
Which two of the following statements describe a routed switch port on a multilayer switch?()
A . Layer 2 switching and Layer 3 routing are mutually supported.
B . The port will not be associated with any VLAN.
C . The routed switch port supports VLAN subinterfaces.
D . The routed switch port is used when a switch has only one port per VLAN or subnet.
E . The routed switch port ensures that STP remains in the forwarding state.
-
Which statements are true about EIGRP successor routes? (Choose two.)()
A . A successor route is used by EIGRP to forward traffic to a destination.
B . Successor routes are saved in the topology table to be used if the primary route fails.
C . Successor routes are flagged as "active" in the routing table.
D . A successor route may be backed up by a feasible successor route.
E . Successor routes are stored in the neighbor table following the discovery process.
-
Which two statements about route redistribution when implementing OSPF are true?()
A . Routes learned using any IP routing protocol can only be redistributed into non IP routing protocols.
B . OSPF can import routes learned using EIGRP, RIP, and IS - IS.
C . OSPF routes cannot be exported into EIGRP, RIP, an d IS - IS.
D . At the interdomain level, OSPF cannot import routes learned using BGP.
E . OSPF routes can be exported into BGP.
-
Which two statements are true about the command ip route 172.16.3.0 255.255.255.0 192.168.2.4 (Choose two.)()。
A . It establishes a static route to the 172.16.3.0 network
B . It establishes a static route to the 192.168.2.0 network
C . It configures the router to send any traffic for an unknown destination to the 172.16.3.0 network
D . It configures the router to send any traffic for an unknown destination out the interface with the address 192.168.2.4
E . It uses the default administrative distance
F . It is a route that would be used last if other routes to the same destination exist
-
Which routing protocol supports a flexible area structure using routing levels one and two?()
A . OSPF
B . EIGRP
C . IS-IS
D . BGP
-
Which two statements are true about IS -IS routing?()
A . Based on the default timers, OSPF d etects a failure faster than IS - IS does.
B . OSPF default timers permit more tuning than IS - IS does.
C . IS - IS is more efficient than OSPF in the use of CPU resources.
D . OSPF is more scalable than IS - IS because of its ability to identify normal, stub, an d NSSA areas.
E . IS - IS and OSPF are both Open Standard, link - state routing protocols which support VLSM.
-
Which two statements about the IS -IS routing protocol are true?()
A . IS - IS is capable of supporting IPv4 and IPv6.
B . IS - IS is only capable of supporting IPv4 and CLNS.
C . IS - IS routers use ES - IS hellos (ESH) to establish and to maintain neighbor relationships.
D . IS - IS routers run the Bellman - Ford algorithm against their LSDBs to pick the best paths.
E . Level 1 routers learn about paths within the area of which they are a part.
F . Level 2 routers learn about paths both within areas and between areas.
-
Which two statements are characteristics of a distance vector routing protocol?()
A . RIP is an example of distance vector routing protocols.
B . Updates are periodic and include the entire routing table.
C . Routing updates are sent only after topology changes
D . The protocol can be useful in hub-and-spoke and hierarchical networks.
E . Convergence is usually faster than with link state protocols
F . Each router has its own view of the topology
-
Which two statements are characteristics of a distance vector routing protocol?()
A . RIP is an example of distance vector routing protocols.
B . Updates are periodic and include the entire routing table.
C . Routing updates are sent only after topology changes
D . The protocol can be useful in hub-and-spoke and hierarchical networks.
E . Convergence is usually faster than with link state protocols
F . Each router has its own view of the topology
-
Which two are advantages of static routing when compared to dynamic routing?()
A . Security increases because only the network administrator may change the routing tables
B . Configuration complexity decreases as network size increases
C . Routing updates are automatically sent to neighbors
D . Route summarization is compued automatically by the router
E . Routing traffic load is reduced when used in stub network links
F . An efficient algorithm is used to build routing tables,using automatic updates
G . Routing tables adapt automatically to topology changes.
-
Which two statements about OSPF IPv6 routing are true?()
A . It requires OSPF version 3.
B . automatically detects neighbors over NHMA interfaces
C . It supports encryption using
D . It uses LSA type 9
E . It uses LSA type 8
-
Which two of these correctly describe asymmetric routing and firewalls?()
A . only operational in routed mode
B . only operational in transparent mode
C . only eight interfaces can belong to an asymmetric routing group
D . operational in both failover and non-failover configurations
E . only operational when the firewall has been configured for failover
-
Which two statements are true about the command ip route 172.16.3.0 255.255.255.0 192.168.2.4? (Choose two.)()
A . It establishes a static route to the 172.16.3.0 network.
B . It establishes a static route to the 192.168.2.0 network.
C . It configures the router to send any traffic for an unknown destination to the 172.16.3.0 network.
D . It configures the router to send any traffic for an unknown destination out the interface with the address 192.168.2.4.
E . It uses the default administrative distance.
F . It is a route that would be used last if other routes to the same destination exist.
-
Which statements are true about EIGRP successor routes (Choose two.)()。
A . A successor route is used by EIGRP to forward traffic to a destination.
B . Successor routes are saved in the topology table to be used if the primary route fails.
C . Successor routes are flagged as "active" in the routing table.
D . A successor route may be backed up by a feasible successor route.
E . Successor routes are stored in the neighbor table following the discovery process.
-
Which two are NOT characteristics of the OSPF routing protocol?()
A . It confines network instability to a single area of network.
B . It increases the routing overhead of the network
C . It supports VLSM
D . It routes between Autonomous Systems.
E . It allows extensive control of routing update
-
Which two provide intra -area routing services?()
A . L1 ES
B . L2 IS
C . L2 ES
D . L1 IS
E . L1/L2 IS
-
Which two of these are characteristics of multicast routing? ()
A . multicast routing uses RPF
B . multicast routing is connectionless.
C . In multicast routing, the source of a packet is known.
D . When network topologies change, multicast distribution trees are not rebuilt, but use the originalpath
E . Multicast routing is much like unicast routing, with the only difference being that it has a a groupof receivers rather than just one destinatio
-
Which two routing interface parameters are supported in OSPF implementations?()
A . retransmit - interval
B . de ad - interval
C . stub area
D . virtual link
E . NSSA area
-
Which two of these correctly describe asymmetric routing and firewalls? ()
A . only operational in routed mode
B . only operational in transparent mode
C . only eight interfaces can belong to an asymmetric routing group
D . operational in both failover and non-failover configurations
E . only operational when the firewall has been configured for failover
-
The Cisco SDM can configure most, but not all, routing protocols. Which two of these routing protocols can be configured using SDM? (Choose two.)()
A . BGP
B . IGRP
C . ISIS
D . OSPF
E . EIGRP
-
Which two are advantages of static routing when compared to dynamic routing?()
A . Security increases because only the network administrator may change the routing tables.
B . Configuration complexity decreases as network size increases.
C . Routing updates are automatically sent to neighbors.
D . Route summarization iscompued automatically by the router.
E . Routing traffic load is reduced when used in stub network links
F . An efficient algorithm is used to build routing tables,using automatic updates.
G . Routing tables adapt automatically to topology changes.
-
Which two static routes are typically configured on your router when a Routed 1483 network is grouping ATM PVCs intoalarge subnet?()
A.host route
B.default route
C.customer network
D.ISP’s routing domain