Each port that is configured to use LACP has an LACP port priority. Which statements are true about LACP port priority? ()
![](/upload/20220827/c85071da6ff0aadc10ebce6c25bb4f0d.png)
相似题目
-
Refer to the exhibit. What is the effect on the trust boundary of configuring the command mls qos trust cos on the switch port that is connected to the IP phone?()https://assets.asklib.com/images/image2/2018072410480466056.jpg
-
What is one of the reasons that custom QoS ACLs are recommended over automatic QoS when configuring ports on a Catalyst 6500 for use with IP phones?()
-
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals?()
-
What value is primarily used to determine which port becomes the root port on each non root switch in a spanning-tree topology?()
-
Refer to the exhibit. What is the effect on the trust boundary of configuring the command mls qos trust cos on the switch port that is connected to the IP phone?()https://assets.asklib.com/images/image2/2018072610064989265.jpg
-
Switch R1 has been configured with Private VLANs. With that type of PVLAN port should the default gateway be configured?()
-
Which of these is true regarding the configuration and application of port access control lists? ()
-
What value is primarily used to determine which port becomes the root port on each nonroot switch in aspanning-tree topology?()
-
The CTI Port Group is configured under which Subsystem?()
-
A port in a redundant topology is currently in the blocking state and is not receiving BPDUs. To ensure that this port does not erroneously transition to the forwarding state, which command should be configured to satisfy the requirement?()
-
When you enable port security on an interface that is also configured with a voice VLAN, what is the maximum number of secure MAC addresses that should be set on the port?()
-
An 802.1Q trunk is not coming up between two switches. The ports on both switches are configured as "switchport mode desirable." Assuming that there is no physical issue,choose two possible causes.()
-
A customer has a Fibre Channel switch residing in a configuration where both production and test data coexist. Which of the following is the simplest method for ensuring that the two types of data do not flow through the same port?()
-
Refer to the exhibit. What is the effect on the trust boundary of configuring the command mls qos trust cos on the switch port that is connected to the IP phone?() https://assets.asklib.com/images/image2/2018073014441668458.jpg
-
A network administrator has a 10base2 network. A card is provided that has both 10base2 and 10base5 ports. Which of the following types of cables should be selected in SMIT during configuration of the adapter?()
-
You have a computer that runs Windows 7. The computer is joined to a domain. You need to ensure thatonly approved USB drives can be used on the computer. Which two policy settings should you configure?(Each correct answer presents part of the solution.()
-
A customer with two x445 servers wants to have two NetXtreme Dual Port Gigabit Ethernet adapters installed in each server. What is the minimally supported configuration that will allow maximum throughput?()
-
Which statement about SAN port channels configured on Cisco Nexus 5000 Series Switches is true?()
-
A new system has been installed and the network connection is very slow. The network administrators are sure that the network port is set to 100 full duplex. What command will display the configured and current speed settings of the adapter?()
-
Switch SW1 has been configured with Private VLANs. With that type of PVLAN port should thedefault gateway be configured?()
-
An 802.1Q trunk is not coming up between two switches. The ports on both switches are configured as "switchport mode desirable." Assuming that there is no physical issue, choose two possible causes.()
-
When configuring a routed port on a Cisco multilayer switch, which of these is a required configuration task that you must perform to enable that port to function as a routed port? ()
-
You are provisioning an E-1 circuit on an ONS 15454 MS-SPRing configuration and XC-VXL-10G card. Each VC-12 connection must also terminate via the VC-3 matrix. How many VC-3 ports remain after this circuit is created, assuming no other circuits?()
-
There are three IS-IS routers on a Gigabit Ethernet segment: Router A, Router B, and Router C. Each router is configured in the same area and each routers Gigabit Ethernet interface is configured for Level 1-only. Router A is the Designated Intermediate System (DIS). Each routers IP address on that segment is:Router A: 10.1.1.1/24Router B: 10.1.1.2/24Router C: 10.2.2.1/26Which statement is true about all the adjacencies that exist on that LAN?()
推荐题目
- 多功能安装置电能表,需量所值误差以相对误差表示。在参比电压、参比频率cos?=1.0时I=0.1Ib-Imax,其需量误差(%)应不大于规定的准确度等级。
- 催芽是通过人为的措施,为种子发芽创造适宜条件,以打破种子的(),促进种子()的措施。
- 价值工程的工作程序一般可分为()四个阶段。
- 如何抵御风暴潮灾害?
- 空调巡检中,用点温计测量进出风口温度,温差为15~16度属正常制冷。()
- 耳聋耳鸣兼见畏寒、发热、脉浮数,除选主穴外宜加用()。
- 请将下列汉字的字体,按照出现的时间顺序排列:①小篆 ②大篆 ③楷书 ④金文 ⑤甲骨文 ⑥隶书
- “共吸附”现象
- 《个人存款账户实名制规定》自()起施行。
- 旅客列车消防安全“四懂四会”中“四会”内容:()。