The purpose of a bilge well is to（）.

相似题目

• The purpose of the purge valve at the top of the condenser in a refrigerating system is to（）

  A . remove any air that may accumulate in the system B . take out unpleasant fumes from the refrigerant C . vent off excess refrigerant in an emergency D . permit opening the refrigerating system for cleaning and inspecting

  查看最佳答案

• The purpose of a devil’s claw is to（）.

  A . act as a chain stopper B . prevent the windlass from engaging C . prevent the chain from fouling on deck D . control the wildcat

  查看最佳答案

• The purpose of compressing the air within the cylinder of a diesel engine is to （）

  A . produce the heat for ignition B . decrease injection lag C . increase ignition delay D . aid in exhausting burnt gase

  查看最佳答案

• The purpose of the flywheel of a diesel engine is to （）.

  A . counterbalance the crank throws on the crankshaft B . keep the engine running smoothly between power stroke C . provide a belt-driving surface for the operation of auxiliary machinery D . prevent the engine from overspeeding

  查看最佳答案

• What is the purpose of a rendezvous point (RP)?（）

  A . acts as a meeting place for sources and receivers of multicast traffic B . used in PIM dense m ode to create a database of all multicast sources C . used in PIM dense and sparse mode to create a database of all multicast sources D . acts as the designated router for a broadcast segment when multicast routing is enabled

  查看最佳答案

• One of the main purposes of refractories in a boiler furnace is to（）

  A . help preheat the air for the furnaces B . help preheat the feedwater C . protect economizer from excessive heat D . prevent excessive furnace heat losse

  查看最佳答案

• The fire pumps must be capable of delivering a total quantity of water at a defined head, not less than （） of the total bilge pumping capacity.

  A . one-third B . two-thirds C . one-fourth D . two-fourth

  查看最佳答案

• What is the purpose of IGMP in a multicast implementation?（）

  A . it is not used in multicast B . it determines the virtual address group for a multicast destination C . it dynamically registers individual hosts in a multicast group on a specific LAN D . it is used on WAN connections to determine the maximum bandwidth of a connection E . it determines whether Bidirectional PIM or PIM sparse mode will be used for a multicast flow

  查看最佳答案

• When bilge water is heated in a holding tank, which one of the following statements is not accurate?（）

  A . The high temperature facilitates primary gravity separation B . Most of the oil and organic solvents are raised to the top layer C . The high the temperature is, the more the top oil will be collected D . The high temperature has little use on the separation of emulsified oil

  查看最佳答案

• What is the purpose of the equalizing beam aboard a crane vessel（）.

  A . It allows for rotation of the hook in the single mode B . It is required to“twin-up”30-ton pedestal cranes C . It is used to pick up light loads D . It is used to rigidly connect two crane

  查看最佳答案

• What is the purpose of IGMP in a multicast implementation？（）

  A .  it is not used in multicast B .  it determines the virtual address group for a multicast destination C .  it dynamically registers individual hosts in a multicast group on a specific LAN D .  it is used on WAN connections to determine the maximum bandwidth of a connection E .  it determines whether Bidirectional PIM or PIM sparse mode will be used for a multicast flow

  查看最佳答案

• The upward slope of a ships bottom from the keel to the bilge is known as（）.

  A . camber B . slope C . deadrise D . keel height

  查看最佳答案

• What is the purpose of a striker plate? （）

  A . Provides surface for applying force on machinery B . Provides landing surface for the sounding bob C . Absorbs machinery vibration D . Prevents valve stem over-travel

  查看最佳答案

• What is a key purpose of the Solutions Recommendation Guide?（）

  A . present Cisco products B . provide a framework of tested and proven models C . identify basic needs of the business D . calculate the business need priority

  查看最佳答案

• The upward slope of a vessels bottom from the keel to the bilge is called（）.

  A . camber B . sheer C . rake D . rise of bottom

  查看最佳答案

• The general purpose of a heat exchanger is to （）.

  A . eliminate hot air from the condenser B . maintain steady pressure in a system C . heat, or cool one fluid by means of another fluid D . reduce the engine room temperature in tropical climate

  查看最佳答案

• The purpose of the tripping line on a sea anchor is to（）.

  A . Aid in casting off B . Direct the drift of the vessel C . Aid in its recovery D . Maintain maximum resistance to broaching

  查看最佳答案

• Which of the following is the purpose of a commemorative speech? ______

  查看最佳答案

• What is the purpose of writing a topic sentence at the beginning of a paragraph?

  查看最佳答案

• A formal mission of a company defines the basic purpose of the organization, especially for external audiences.

  查看最佳答案

• 116．The purpose of a bilge well is to ___.

  查看最佳答案

• Which of the following was not a purpose of Shackleton's adventure？

  A．To do scientific research. B．To show his strength. C．To explore a dangerous place. D．To know more about Antarctica.

  查看最佳答案

• Battens are fitted in cargo holds across the frames of the vessel from the turn of the bilge Upward.The purpose of these cargo battens is ______.

  A.for securing a snatch block when snaking cargo into the wings of the hold B.to prevent cargo from coming in contact with the vessel’s frames or shell plating C.to provide fittings to which cargo lashings may be secured D.to support the dunnage floors which are laid down between tiers of cargo

  查看最佳答案

• The purpose of the arrowheads on a cutting plane line is to:

  A．show the direction in which the imaginary cut surface is viewed B．indicate the location of the cutting plane C．identify the reference letters such as section A-A or B-B,etC D．all of the above

  查看最佳答案