Client traffic is being bridged through LAN interfaces on two WLCs. Which roaming option will keep them on the same IP subnet？（）

相似题目

• What must be true about the client before upstream traffic stream metrics can be displayed on the Cisco WLC?（）

  A . must be Cisco Compatible Extensions version 2 B . must be Cisco Compatible Extensions version 3 C . must be Cisco Compatible Extensions version 4 D . must be associated to a Platinum QoS WLAN E . must be associated to an access point on a Cisco WLC with code version 5.0 or newer

  查看最佳答案

• The boot .net.tcp.client fileset is broken. Which of the following procedures must be performed to fix the problem?（）

  A . Reinstall with the Force Overwrite option B . Update the fileset at a lower level C . Install the update in the commit state D . Reboot the system to fix the broken filelist

  查看最佳答案

• Which configuration prevents traffic that is sourced from the unique local address scope to be sent out ofthe link to the upstream service provider？（）

  A . interface Ethernet0/0 I.pv6 traffic-filter NoULA out I.pv6 access-list NoULA Deny ipv6 FC00：：/8 any Permit ipv6 any any B . interface Ethernet0/0 I.pv6 traffic-filter NoULA out I.pv6 access-list NoULA Deny ipv6 FC00：：/7 anyP ermit ipv8 any any C . interface Ethernet0/0 I.pv6 access-group NoULA out I.pv6 access-list NoULA Deny ipv6 FC00：：/8 anyP ermit ipv6 any any D . interface Ethernet0/0 I.pv6 access-group NoULA out I.pv6 access-list NoULA Deny ipv6 FC00：：/7 any Permit ipv6 any any

  查看最佳答案

• A client is experiencing issues after cloning an LPAR using alt_disk_install. DLPAR functions are not available for the new LPAR. Also, there is a lot of network traffic to the HMC. What is the most probable cause of this problem?（）

  A . DLPAR functions are not available for cloned partitions B . The new partition has the same node number as the original LPAR C . Additional filesets need to be reinstalled after the alt_disk_install cloning D . The speed and duplex settings on the Ethernet adapter on the new LPAR is misconfigured

  查看最佳答案

• Which tasks can NOT be performed at the management console if the Client ID is being used?（）

  A . Reboot the HMC B . Access the storage manager C . Shut down the console D . Access the storage system diagnostic

  查看最佳答案

• If a certificate authority trustpoint is not configured when enabling HTTPS and the remote HTTPS server requires client authentication，connections to the secure HTTP client will fail. Which command must be enabled for correct operation？（）

  A . ip http client secure-ciphersuite 3des-ede-cbc-sha B . ip https max-connections 10 C . ip http timeout-policy idle 30 life 120 requests 100 D . ip http client secure-trustpoint trustpoint-name

  查看最佳答案

• The Client has requested that once Terms and Conditions （Ts Cs） are attached to another record， the Ts Cs should be unchangeable. How is this appropriately accomplished？（）

  A .  In the Contracts application， delete the Ts Cs from the record and enter a new row. B .  In the application using the specific Ts Cs， rename the Ts Cs and approve the record. C .  In the Terms and Conditions Application， uncheck the Editable box on the newly created term. D .  In the Terms and Conditions Application， change the status of the newly created term to Approved.

  查看最佳答案

• Which roaming option will keep them on the same IP subnet when client traffic is being bridged through LAN interfaces on two WLCs？（）

  A .  Layer 1 intercontroller roaming B .  Layer 2 intercontroller roaming C .  Layer 3 intercontroller roaming D .  Layer 4 intercontroller roaming

  查看最佳答案

• If the VoWLAN client is a Vocera badge, which Cisco WLC parameter needs to be changed from the default value?（）

  A . DTIM B . Ethernet multicast mode C . peer-to-peer block mode D . RF group mode E . DTPC

  查看最佳答案

• A system administrator is installing a p5 590 server with an HMC. After pulling the websm client down, it is not possible to connect to the HMC. The HMC can be pinged from the client. Which of the following settings should be verified next?（）

  A . The routes on the HMC B . The firewall setting of the LAN adapter C . The name resolution protocol on the p5 590 server D . The subnet mask settings on the Ethernet adapter

  查看最佳答案

• Refer to the exhibit. Based upon the information that is given， how will voice traffic from the phone  and data traffic from the PC be handled by SW_1？ （） https://assets.asklib.com/images/image2/2018073014240858976.jpg

  A . The switch port will perform marking for the ingress voice and data traffic by using the  defaultCoS value at the switch port. B . The switch port will trust theCoS value of the ingress voice and data traffic that comes into the  switch port. C . The switch port will trust theCoS value of the ingress voice traffic. Data traffic will be marked at  the switch port with the default CoS value. D . The switch port will trust theCoS value of the ingress data traffic. Voice traffic will be marked at  the switch port with the default CoS value.

  查看最佳答案

• Client traffic is being bridged through LAN interfaces on two WLCs. Which roaming option will keep them on the same IP subnet?（）

  A . Layer 1 intercontroller roaming B . Layer 2 intercontroller roaming C . Layer 3 intercontroller roaming D . intracontroller roaming

  查看最佳答案

• Which roaming option will keep them on the same IP subnet when client traffic is being bridged through LAN interfaces on two WLCs?（）

  A . Layer 1intercontroller roaming B . Layer 2intercontroller roaming C . Layer 3intercontroller roaming D . Layer 4intercontroller roaming

  查看最佳答案

• An IP address is 198.37.16.23.  Which of the following router’s IP addresses should be used to route traffic to the 193.130.56.0 network？（）

  A . 193.130.56.0 B . 198.37.16.15 C . 198.130.16.15 D . 198.130.56.15

  查看最佳答案

• A client roams from h-reap ap1 to h-reap ap2. the client is unable to associate to h-reap ap2. h-reap ap2 has six other clients associated to it， which continue to pass traffic. What has caused this problem？（）

  A . h-reap ap1 has reached its client limit. B . h-reap ap2 has reached its client limit. C . h-reap ap2 lost its connection to the controller. D . h-reap ap1 lost its connection to the controller.

  查看最佳答案

• A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2.H-REAP AP2 has six other clients associated to it， which continue to pass traffic. What has causedthis problem？（）

  A . H-REAP AP1 lost its connection to the controller. B . H-REAP AP2 lost its connection to the controller. C . H-REAP AP1 has reached its client limit. D . H-REAP AP2 has reached its client limit.

  查看最佳答案

• A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAPAP2. H-REAP AP2 has six other clients associated to it，which continue to pass traffic. What hascaused thisproblem？（）

  A . H-REAP AP1 has reached its client limit. B . H-REAP AP2 has reached its client limit. C . H-REAP AP2 lost its connection to the controller. D . H-REAP AP1 lost its connection to the controller.

  查看最佳答案

• A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2. H-REAP AP2 has six other clients associated to it， which continue to pass traffic. What has caused this problem？（）

  A . H-REAP AP1 lost its connection to the controller. B . H-REAP AP2 lost its connection to the controller. C . H-REAP AP1 has reached its client limit. D . H-REAP AP2 has reached its client limit.

  查看最佳答案

• A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2.H-REAP AP2 has six other clients associated to it，which continue to pass traffic. What has causedthis problem？（）

  A . H-REAP AP1 has reached its client limit. B . H-REAP AP2 has reached its client limit. C . H-REAP AP2 lost its connection to the controller. D . H-REAP AP1 lost its connection to the controller.

  查看最佳答案

• A network is composed of several VRFs. It is required that VRF users VRF_A and VRF_B be able to route to and from VRF_C， which hosts shared services. However， traffic must not be allowed to flow between VRF_A and VRF_B. How can this be accomplished？（）

  A . route redistribution B . import and export using route descriptors C . import and export using route targets D . Cisco MPLS Traffic Engineering

  查看最佳答案

• （） is not likely to be a methods of Traffic Separation.

  A . Separation of opposing streams of traffic by separation zones or lines B . The separation of through traffic from local traffic by provision of inshore traffic zones C . Division of traffic from several different direction into sectors D . Control of routing traffic through shipping route

  查看最佳答案

• An LWAPP encapsulated packet is being sent from the Cisco WLC v5.2 to the AP for a wireless WMM client. Can the LWAPP frame be altered to change the resulting final WMM queue for transmission on an 802.11 client?（）

  A . Yes，by modifying the LWAPP frame header DSCP value in transit. B . Yes，by modifying the LWAPP frame header 802.1p value in transit. C . No，the WMM queue classification parameter is transported inside the LWAPP tunnel. D . No，the WMM queue classification parameter is determined at the AP based on the original client IP header DSCP value.

  查看最佳答案

• Simultaneous Multithreading （SMT） is enabled in a POWER6 VIO client running AIX 6.1.  Which command would be used to disable it after the next operating system reboot is performed？（）

  A .  schedo -o smt=0 -p B .  smtctl -m off -w boot C .  chdev -l sys0 -a smt=off D .  echo 0 > /proc/sys/smt_enable

  查看最佳答案

• A client will be creating partitions on multiple systems with identical configurations. What is the recommended method for cloning the master partition?（）

  A . Create a mksysb backup of the original and restore it to the new partitions B . Use NIM to load the additional partitions from an image of the original partition C . Create alt_disk_install clones of the original partition and assign the target disks to the new partitions D . Use the split mirror function to split off additional copies of the original partition and assign them to the other partitio

  查看最佳答案