The center line condition of the transmission shaft can be checked by（）

相似题目

• Because the actual center of some planets may differ from the observed center，the navigator applies a correction known as the（）.

  A . phase correction B . refraction correction C . semidiameter correction D . augmentation correctio

  查看最佳答案

• Laying out a line in successive circles flat on deck with the bitter end in the center is known as（）.

  A . coiling B . faking C . flemishing D . lining

  查看最佳答案

• 线路中心线 center line of track

  查看最佳答案

• The geometric center of the waterplane area is called the（）.

  A . center of buoyancy B . center of gravity C . metacenter D . center of flotatio

  查看最佳答案

• The apparent wind’s speed can be zero only when two conditions are present. One condition is that the true wind（）.

  A . must be from dead ahead B . speed must be zero C . must be from dead astern D . must be on the beam

  查看最佳答案

• If a vessel under tow starts jumping on its tow line，the most appropriate action to alleviate the condition is to（）.

  A . change course B . slow down C . heave to D . adjust tow line length

  查看最佳答案

• A crankshaft whose center of gravity coincides with its center line is said to be （）.

  A . dynamically balanced B . statically balanced C . counter balanced D . resonantly balanced

  查看最佳答案

• You are inspecting the lower main precision bearings on a diesel engine.You observe that about half the thin Babbitt linings are of a milky white colourThis condition is caused by （）

  A . large dirt particles in the oil supply B . insufficient lubricating oil and overheating C . normal wear D . water contamination of the lube oil

  查看最佳答案

• The maneuvering information required to be posted in the wheelhouse must be based on certain conditions.Which of the following is NOT one of these conditions?（）

  A、 The hull must be clean B、 There must be calm weather – wind 10 knots or less and a calm sea C、 There must be no currents D、 The depth of the water must be at least one and one-half times the draft

  查看最佳答案

• For a floating vessel，the center of buoyancy and the metacenter are in the line of action of the buoyant force（）.

  A . only when there is positive stability B . only when there is negative stability C . only when there is neutral stability D . at all time

  查看最佳答案

• The center of buoyancy and the metacenter are in the line of action of the buoyant force（）.

  A . only when there is positive stability B . only when there is negative stability C . only when there is neutral stability D . at all time

  查看最佳答案

• Which mooring line is likely to undergo the most strain when docking a ship under normal conditions?（）

  A . Bow line B . Breast line C . Spring line D . Stern line

  查看最佳答案

• Under normal operating conditions, the highest temperature and pressure conditions existing in a flash-type evaporator will occur in the （）.

  A . first stage B . second stage C . distillate cooler D . salt water feed heater

  查看最佳答案

• A sight glass is installed in the liquid line to indicate the condition of the refrigerant charge and may also indicate the （）.

  A . condition of the expansion valve B . moisture in the system C . condition of the compressor suction valves D . condenser temperature

  查看最佳答案

• When a ship in loaded condition floats at arbitrary water line, its displacement is to the relevant mass of water displaced by the ship（）

  A . equal B . larger C . smaller D . equivalent

  查看最佳答案

• A crankshaft whose center of gravity coincides with its center line is said to be（） Ⅰ.statically balanced Ⅱ.dynamically balanced

  A . Ⅰ only B . Ⅱ only C . both Ⅰ and Ⅱ D . neither Ⅰ nor Ⅱ

  查看最佳答案

• The center of volume of the immersed portion of the hull is called the（）.

  A . center of buoyancy B . center of flotation C . center of gravity D . tipping center

  查看最佳答案

• The condition where a ship on the end of a tow line is riding a wave crest at the same time as its tug rides a wave crest is known as riding in（）.

  A . synchronism B . harmony C . check D . ste

  查看最佳答案

• A frame with two，or sometimes four，arms through which are threaded the guidelines and which is used to keep the drill stem and bit in line with the center opening in the temporary guide base is the（）.

  A . drill stem guide B . guide frame C . drill string frame D . casing guide

  查看最佳答案

• When liquid reaches the compressor of a refrigeration system through the suction line, the condition is called （）.

  A . flooding back B . superheating C . overflowing D . recycling

  查看最佳答案

• 道岔中心线表示法 method of indicating the center line of turnout

  查看最佳答案

• The center of the underwater volume of a floating vessel is the（）.

  A . center of buoyancy B . center of flotation C . uncorrected height of the center of gravity of the vessel D . center of gravity of the vessel corrected for free surface effect

  查看最佳答案

• （）is the main center-line structural member，running fore and aft along the bottom of a ship，sometimes referred to as the backbone.

  A . Frame B . Deckbeam C . Stringer D . Keel

  查看最佳答案

• Find the center and vertices of the ellipse. （）

  A．center: vertices: B．center: vertices: C．center: vertices: D．center: vertices: E．center: vertices:

  查看最佳答案