Refer to the exhibit.What two results would occur if the hub were to be replaced with a switch that is configured with one Ethernet VLAN?（）https://assets.asklib.com/images/image2/2018072316420345545.jpg

相似题目

• Refer to the exhibit. What is the meaning of the output MTU 1500 bytes?（）https://assets.asklib.com/images/image2/2018072317543588105.jpg

  A . Themaximumnumberofbytesthatcantraversethisinterfacepersecondis1500. B . Theminimumsegmentsizethatcantraversethisinterfaceis1500bytes. C . Theminimumpacketsizethatcantraversethisinterfaceis1500bytes. D . Themaximumpacketsizethatcantraversethisinterfaceis1500bytes. E . Themaximumframesizethatcantraversethisinterfaceis1500bytes.

  查看最佳答案

• Refer to the exhibit. What is the configuration an example of？ （） https://assets.asklib.com/images/image2/2018073015220049716.jpg

  A .  GLBP weighting B .  default AVF and AVG configuration C .  GLBP MD5 authentication D .  GLBP text authentication E .  GLBP timer manipulatio

  查看最佳答案

• Refer to the exhibit. What can be determined about the router from the console output?（）https://assets.asklib.com/images/image2/201807231045561661.jpg

  A . No configuration file was found in NVRAM. B . No configuration file was found in flash. C . No configuration file was found in the PCMCIA card. D . Configuration file is normal and will load in 15 seconds.

  查看最佳答案

• Refer to the exhibit. What does the command channel-group 1 mode desirable do？ （） https://assets.asklib.com/images/image2/2018073109243663160.jpg

  A . enables LACP unconditionally B . enables PAgP only if a PAgP device is detected C . enables PAgP unconditionally D . enables Etherchannel only E . enables LACP only if a LACP device is detected

  查看最佳答案

• Refer to the exhibit. What is required to complete the IPv6 routing configurations shown?（）https://assets.asklib.com/images/image2/2018073015315977122.jpg

  A . Interface authentication must be configured B . The routing processes must be configured with an area ID C . IP unicast routing must be enabled D . IPv4 ad dresses must be applied to the interface

  查看最佳答案

• Refer to the exhibit. What two statements are true？（）https://assets.asklib.com/images/image2/2018072615071070209.jpg

  A . The IP address of the backup designated router （BDR） is FE80：：205：5FFF：FED3：5808 B . This is the designated router （DR） on the FastEthernet 0/0 link C . Interface FastEthernet 0/0 was configured with the ipv6 ospf 1 area 1 command D . OSPF version 2 has been enabled to support IPv6 E . The output was generated by the show ip interface command

  查看最佳答案

• Refer to the exhibit. What two statements are true?（）https://assets.asklib.com/images/image2/2018073014095357352.jpg

  A . This is the designated router (DR) on the FastEthernet 0/0 link. B . The output was generated by the show ip interface c ommand. C . The router was configured with the commands:r outer ospf 1 network 172.16.6.0 0.0.0.255 area 1 D . The IP address of the backup designated router (BDR) is FE80::205:5FFF:FED3:5808. E . Interface FastEthernet 0/0 was configured with the ipv6 o spf 1 area 1 command. F . OSPF version 2 has been enabled to support IPv6.

  查看最佳答案

• Refer to the exhibit. What command sequence will enable PAT from the inside to outside network?（）https://assets.asklib.com/images/image2/2018072310395019011.jpg

  A . (config) ip nat pool isp-net 1.2.4.2 netmask 255.255.255.0 overload B . (config-if) ip nat outside overload C . (config) ip nat inside source list 1 interface ethernet1 overload D . (config-if) ip nat inside overload

  查看最佳答案

• Refer to the exhibit. What three statements are true about the IS - IS configuration?（）https://assets.asklib.com/images/image2/2018073015191336049.jpg

  A . The router is in area 49.0001.0002 B . The router acts as a Level 1 - 2 router C . CLNS routing is enable d for the router D . The router has a system ID of 0003.0004 E . The interfaces have a functional IS - IS configuration F . The network service access point selector (NSEL) byte has a value of 0

  查看最佳答案

• Refer to the exhibit. What does the option secret 5 in the username global configuration mode commandindicate about the enable secret password？（）

  A . It is hashed using SHA B . It is encrypted using DH group 5 C . It is hashed using MD5 D . It is encrypted via the service password-encryption command E . It is hashed using a proprietary Cisco hashing algorithm F . It is encrypted using a proprietary Cisco encryption algorithm

  查看最佳答案

• Refer to the exhibit.What is the reason that the interface status is “administratively down,line protocol down”?（）

  A . There is a mismatch in encapsulation types B . The wrong type of cable is connected to the interface C . The interface has been configured with the shutdown command D . The interface is not receiving any keepalives E . The interface needs to be configured as a DTE device F . There is no encapsulation type configured

  查看最佳答案

• Refer to the exhibit. What statement is true about the interface S1/0 on router R1？（）https://assets.asklib.com/images/image2/2018072411394669613.jpg

  A . Labeled packets can be sent over an interface. B . MPLS Layer 2 negotiations have occurred. C . IP label switching has been disabled on this interface. D . None of the MPLS protocols have been configured on the interface.

  查看最佳答案

• Refer to the exhibit. What is the most appropriate summarization for these routes?（）https://assets.asklib.com/images/image2/2018072410531258943.jpg

  A . 10.0.0.0/21 B . 10.0.0.0/22 C . 10.0.0.0/23 D . 10.0.0.0/24

  查看最佳答案

• Refer to the exhibit. What enterprise IP telephony deployment model is represented？（）https://assets.asklib.com/images/image2/2018072416060627546.jpg

  A . core distribution access B . multisite with centralized call processing C . multisite with distributed call processing D . clustering over WAN E . PSTN-WAN F . Enterprise Composite Model

  查看最佳答案

• Refer to the exhibit. What statement is true of the configuration for this network?（）https://assets.asklib.com/images/image2/2018072409051390056.jpg

  A . The configuration that is shown provides inadequate outside address space for translation of the number of inside addresses that are supported. B . Because of the addressing on interface FastEthernet0/1, the Serial0/0 interface address will not support the NAT configuration as shown. C . The number 1 referred to in the ip nat inside souce command recerences access-list number 1. D . ExternalRouter must be configured with static routers to network 172.16.2.0/24

  查看最佳答案

• Refer to the exhibit.What is the effect of the configuration that is shown?（）

  A . It tells the router or switch to try establish an SSH connection first and if that fail to use telnet. B . It configures a cisco network device to use the SSH protocol on incoming communications via the virtual terminal ports. C . It allows seven failed login attempts before the VTY lines are temporarily shutdown. D . It configures the virtual terminal lines with the password 030752180500. E . It configures SSH globally for all logins.

  查看最佳答案

• Refer to the exhibit. What does the (*) represent in the output?（）https://assets.asklib.com/images/image2/2018072310402175939.jpg

  A . Packet is destined for a local interface to the router. B . Packet was translated, but no response was received from the distant device. C . Packet was not translated, because no additional ports are available. D . Packet was translated and fast switched to the destination.

  查看最佳答案

• Refer to the exhibit. What is the configuration an example of？（）

  A . enabling modular QoS over Frame Relay B . enabling Real-Time Transport Protocol （RTP） header compression C . enabling distributed compressed Transmission Control Protocol D . enabling latency and jitter reduction for Transmission Control traffic E . enabling TCP header compressio

  查看最佳答案

• Refer to the exhibit.What is the result of setting the no login command？（）https://assets.asklib.com/images/image2/2018072314480141170.jpg

  A . The is a virtually limitless supply of IP addresses B . Telnet access requires a new password at first login C . Telnet access requires a password D . Telnet access is denied

  查看最佳答案

• Refer to the exhibit. What type of attack is being defended against？ （） https://assets.asklib.com/images/image2/201807301110426.jpg

  A .  snooping attack B .  rogue device attack C .  STP attack D .  VLAN attack E .  spoofing attack F .  MAC flooding attack

  查看最佳答案

• Refer to the exhibit. What is the problem with this configuration？（） https://assets.asklib.com/images/image2/201807301056416734.jpg

  A .  Spanning tree PortFast cannot be configured on a port where a voice VLAN is configured. B .  Sticky secure MAC addresses cannot be used on a port when a voice VLAN is configured. C .  Spanning tree PortFast cannot be configured on a port when a sticky secure MAC address is  used. D .  The switch port must be configured as a trunk.

  查看最佳答案

• Refer to the exhibit. What statement is true base d upon the configuration in the exhibit? （）https://assets.asklib.com/images/image2/2018073015050639705.jpg

  A . CGMP version 2 is being used. B . The switch will use sparse mode first, dense mode second. C . A rendezvous point must be configured in order for the interface to operate in sparse mode. D . IGMP version 2 is being used. E . The rendezvous point is IP address 172.16.4.16. F . If a rendezvous point is configured, the interface cannot operate in dense mode.

  查看最佳答案

• Refer to the exhibit. What command was issued on the Layer 3 switch Sw1 between Exhibit #1 and Exhibit #2？（） https://assets.asklib.com/images/image2/2018073109320145794.jpg

  A . ip routing B . no ip routing C . router eigrp 1 D . no router eigrp 1 E . mls qos F . no mls qo

  查看最佳答案

• Refer to the exhibit. What will Router1 do when it receives the data frame shown？（）

  <img src='https://img2.soutiyun.com/ask/uploadfile/2019-02-05/72ab8f6538ac9ce22dc27503a9f6be9f.jpg' /> A.Router1 will strip off the source MAC address and replace it with the MAC address 0000.0c36.6965. B.Router1 will strip off the source IP address and replace it with the IP address 192.168.40.1. C.Router1 will strip off the destination MAC address and replace it with the MAC address 0000.0c07.4320. D. Router1 will strip off the destination IP address and replace it with the IP address of 192.168.40.1. E.Router1 will forward the data packet out interface FastEthernet0/1. F.Router1 will forward the data packet out interface FastEthernet0/2.

  查看最佳答案

• Refer to the exhibit. What additional commands should be used to configure OSPF area 5 as a Totally Stubby area？ （）

  <img src='https://img2.soutiyun.com/shangxueba/ask/64290001-64293000/64291910/529008d927b67f31920b5858e5879e0b.png' /> A. area 0 stub o n routers R4 and R5 B. area 5 stub on routers R4 and R5 C. area 5 stub no - summary on routers R4 and R5 D. area 0 stub no - summary on router R4 and area 5 stub no - summary on router R5 E. area 5 stub no - summary on router R4 and area 5 stub on router R5

  查看最佳答案