Diesel powered industrial trucks on a ship that are provided with safeguards to the exhaust，fuel，and electrical systems are designated（）.

相似题目

• 工业站 industrial station

  查看最佳答案

• A diesel engine will lose power if fuel injection occurs too early because the （）

  A . fuel will not be properly atomized in the cylinder B . ignition will be delayed due to low ignition temperature C . maximum fuel expansion will occur on the compression stroke D . fuel will ignite before top dead center

  查看最佳答案

• 英译中：Industrial engineering

  查看最佳答案

• 专用线 industrial siding

  查看最佳答案

• On a four-stroke diesel engine, when the piston is driven downwards by the expanding gas, it delivers power to the crankshaft through the （）.

  A . thrust block B . sounding rod C . connecting rod D . push rod

  查看最佳答案

• In a single acting, two-stroke/cycle, diesel generator engine, the power impulse in an individual cylinder occurs （）

  A . once every crankshaft revolution B . once every two crankshaft revolutions C . once every piston stroke D . twice every piston stoke

  查看最佳答案

• The essential part of the diesel engine, whose function is to convert the heat energy into the mechanical power, is the （）.

  A . crankshaft B . piston C . connecting rod D . bearing

  查看最佳答案

• In a four-stroke/cycle diesel engine, after the completion of the power stroke, the piston will move（）

  A . up and draw in a fresh air charge B . down to burn off fuel C . down to compress the fuel air charge D . up and force out the exhaust gase

  查看最佳答案

• The heart of the diesel engine is the （） where the fuel is burnt and the power developed.

  A . crankcase B . cylinder C . scavenge box D . pisto

  查看最佳答案

• During the power stroke of a four-stroke/cycle diesel engine, most of the side thrust of a trunk-type piston is absorbed by the（）

  A . piston skirt B . pinion C . crosshead D . compression ring

  查看最佳答案

• The power output of a turbocharged diesel engine will drop if the cooling water flow through the after-cooler is interrupted because the （）.

  A . turbocharger stalls B . exhaust pressure increases C . air charge density decreases D . scavenge effect increase

  查看最佳答案

• The reason why more and more of the large merchant vessels are being powered by medium-speed diesel engines is （）.

  A . they operate between 150 and 450 rpm B . they are connected to the propeller by gearing C . their smaller size and weight D . they can be connected directly to the propeller without gearing

  查看最佳答案

• A diesel engine will lose power if fuel injection occurs too late in the cycle, because the（）

  A . fuel droplets will burn as they leave the fuel injector B . fuel will not be properly atomized in the cylinder C . maximum expansion of the burned fuel cannot take place in the cylinder D . compression pressure will be too low to cause fuel ignitio

  查看最佳答案

• The UK economy can be divided into three main sectors（）industries,secondary industries and（）industries.

  查看最佳答案

• Industry 4.0 is looking for ( )

  查看最佳答案

• Pharmaceutical industry is a special industry for the people’s _________ and _________.

  查看最佳答案

• This is your chance to show off your industry knowledge.Industry knowledge here means____

  查看最佳答案

• The agent in channel ‘Producer—agent—industrial distributor—organizational buyer’ takes a commission on sales it secures with industrial distributors.

  查看最佳答案

• The power output of a turbocharged diesel engine will drop if the cooling water flow through the after-cooler is interrupted because the _____.

  A.turbocharger stalls B.exhaust pressure increases C.air charge density decreases D.scavenge effect increases

  查看最佳答案

• Industry overcapacity and increased cost cutting characterize which stage of the industry life cycle？

  A．Growth. B．Shakeout. C．Maturity.

  查看最佳答案

• During the power stroke of a four-stroke/cycle diesel engine, most of the side thrust of a trunk-type piston is absorbed by the_____________.

  A.piston skirt B.pinion C.crosshead D.compression rings

  查看最佳答案

• Which of the following is NOT an effect of intra-industry trade, if the concerned industry is monopolistically competitive？

  A．There are considerable national gains that arise from trade because there is an increase in the number of varieties of products available in the country． B．Domestic consumers gain because such trade results in lower prices of domestic varieties of the gooD C．Total output of the domestic firms in the industry increases as a result of such trade D．There are few shifts in production between industries that put pressures on factor prices．

  查看最佳答案

• Society was fascinated by science and things scientific in the nineteenth century. Great breakthroughs in engineering, the use of steam power, and electricity were there for all to see, enjoy, and suffer. Science was fashionable and it is not surprising that, daring this great period of industrial development, scientific methods should be applied to the activities of man, particularly to those involved in the processes of production. Towards the end of the nineteenth century international competition began to make itself felt. The three industrial giants of the day, Germany, America, and Great Britain, began to find that there was a limit to the purchasing power of the previously apparently inexhaustible markets. Science and competition therefore provided the means and the need to improve industrial efficiency.

  Frederick Winslow Taylor is generally acknowledged as being the father of the scientific management approach, as a result of the publication of his book, The Principles of Scientific Management, published in 1911. However, numerous other academics and practitioners(实践者) had been actively applying such approaches since the beginning of the century. Charles Babbage, an English academic, well-known for his invention of the mechanical computer(with the aid of a government grant as long as 1820), applied himself to the costing of processes, using scientific methods, and indeed might well be recognized as one of the fathers of cost accounting. Taylor was of well-to-do background and received an excellent education but, partly owing to troubles with his eyesight, decided to become an engineering apprentice. He spent some twenty-five years in the tough, sometimes brutal, environment of the US steel industry and carefully studied methods of work when he eventually attained supervisory status. He made various significant innovations in the area of steel processing, but his claim to fame is through his application of methods of science to methods of work, and his personal efforts that proved they could succeed in a hostile environment. In 1901, Taylor left the steel industry and spent the rest of his life trying to promote the principles of managing scientifically and emphasizing the human aspects of the method, over the slave-driving methods common in his day. He died in 1915, leaving a huge school of followers to promote his approach worldwide. According to the passage, what was badly needed to improve industrial efficiency？ A．Great breakthroughs. B．Unlimited purchasing power. C．Science and competition. D．International competition.

  查看最佳答案

• The massive industrial plant fitted with special equipment to recycle energy can reduce power costs as well as_______,

  查看最佳答案