The gas loads on the engine structure are constrained by means of hydraulically preloaded （） which connect the bed plate, frame sections and cylinder jackets into a single unit.

相似题目

• The exhaust boilers are used to recover some of （） carried in the exhaust gas from the main engine.

  A . water B . oil C . heat D . steam

  查看最佳答案

• During loading and discharging operations，in addition to when the cargo tanks have been properly filled，each inert gas system must be capable of maintaining a minimum gas pressure of（）.

  A . 150 millimeters of water pressure B . 125 millimeters of water pressure C . 100 millimeters of water pressure D . 75 millimeters of water pressure

  查看最佳答案

• Compliance with the terms of the load line certificate on a ship is the responsibility of the（）.

  A . Ballast Control Operator B . Barge Supervisor C . Master or Offshore Installation Manager D . operators representative

  查看最佳答案

• During sea trial, the main engine well be kept run at load（）

  A . 100% B . 110% C . 85% D . different

  查看最佳答案

• The exhaust gases for a new engine should be （） when the engine operates under full load.

  A . smoky B . a little bit dense C . visible D . almost invisible

  查看最佳答案

• On a ship’s crane，the load chart relates the allowable load to the combination of the boom length and（）.

  A . winch speed B . boom strength C . load radius D . cable strength

  查看最佳答案

• Increasing the load on an engine equipped with a constant speed mechanical governor, will cause the engine speed to initially （）.

  A . increase B . decrease C . fluctuate D . remain constant

  查看最佳答案

• On a four-stroke diesel engine, when the piston is driven downwards by the expanding gas, it delivers power to the crankshaft through the （）.

  A . thrust block B . sounding rod C . connecting rod D . push rod

  查看最佳答案

• Compliance with the terms of the load line certificate on a vessel is the responsibility of the（）.

  A . Ballast Control Operator B . Barge Supervisor C . Master or Offshore Installation Manager D . operators representative

  查看最佳答案

• What is the best indication of the loading of a diesel engine?（）

  A . Oil temperature B . Manifold pressure C . Exhaust gas temperature D . Fuel consumptio

  查看最佳答案

• The deck loads on a ship are distributed through the deck beams to the（）.

  A . frames B . hull C . stringers D . plate

  查看最佳答案

• The diesel engine exhaust gas bypass, as fitted with some waste heat boilers, is installed to （）

  A . prevent engine back pressure at heavy loads B . increase total engine efficiency at low loads C . prevent boiler corrosion at low engine loads D . improve engine fuel consumption at any load

  查看最佳答案

• If a diesel engine is smoking excessively under load, the cause could be （）

  A . low exhaust back pressure B . early fuel injection in one of the cylinders C . compression pressure in one of the cylinders D . plugged injector hole

  查看最佳答案

• Gas exchange, which is a basic part of the cycle of an internal combustion engine, is（）

  A . the supply of normal air and removal of compressed air B . the supply of fuel oil and combustion of the atomized oil C . the supply of fresh air and removal of exhaust gases D . the supply of fresh air and removal of the extra heat

  查看最佳答案

• An increase in load on a diesel engine results in （） of speed of the crankshaft.

  A . a reduction B . an increase C . an outing D . a downward

  查看最佳答案

• When a diesel engine is operate at partial load, as compared to full load ,a decrease will occur in the average （）

  A . air quantity aspirated B . fuel injection pressure C . combustion pressure on the power stroke D . compression on the compression stroke

  查看最佳答案

• The highest loads applied to the diesel engine crankshaft main bearings are （）

  A . axial loads B . firing loads C . inertia loads D . centripetal load

  查看最佳答案

• With VIT the start of injection may be （） as the engine load is reduced within a certain range.

  A . advanced B . retarded C . relayed D . cut off

  查看最佳答案

• What monitoring device best indicates the load being carried by a diesel engine?（）

  A . Lube oil pressure gauge B . Jacket water temperature gauge C . Tachometer D . Exhaust pyrometer

  查看最佳答案

• On a ship crane，the load chart relates the allowable load to the combination of boom length and（）.

  A . boom angle B . boom strength C . load radius D . cable strength

  查看最佳答案

• The greatest strain，when lifting a load with the jumbo purchase，is on（）.

  A . all of the parts，dividing the load equally B . the hauling part because it must absorb the frictional losses of all the sheaves C . the parts in the movable block D . the standing part because it is directly connected to the weight

  查看最佳答案

• When the load is increased on a turbocharged diesel engine, the amount of increased air supplied by the turbocharger will___________.

  A.lag behind the increased fuel supplied to the engine B.enter the engine along with the increase in the fuel C.enter the engine before the increased fuel supply D.leave the turbocharger as a negative pulse

  查看最佳答案

• In a modern internal combustion diesel engine, the load carrying part of the engine is referred to as the________.

  A.bedplate or base B.sump or oil pan C.cylinder block D.frame.

  查看最佳答案

• With V1T the start of injection may be _____ as the engine load is reduced within a certain range.

  A.advanced B.retarded C.relayed D.cut off

  查看最佳答案