Buckler plates are().
![](/upload/20220827/c85071da6ff0aadc10ebce6c25bb4f0d.png)
相似题目
-
The joint formed when two steel plates are placed end-to-end is called a().
-
英译中:Number plate
-
Owing to the greater girth of a ship amidships than at the ends,certain strakes are dropped as they approach the bow and stern to reduce the amount of plating at the ends. These strakes are called().
-
The welds used to join shell plates in flush construction are known as().
-
Lighter longitudinal stiffening frames on the vessel side plating are called().
-
All of the following operating characteristics are listed on the name-plates of motors used aboard ship except the()
-
涂布平板法(spread plate method)
-
The welds used to attach stiffeners to a plate are known as().
-
A solution to overcome tripping defects is an arrangement of special plates on either side of the flukes,designed to set them in the correct tripping position. These special plates are called().
-
Aboard ship,vertical flat plates running transversely and connecting the vertical keel to the margin plates are called().
-
Aboard ship, vertical flat plates running transverely and connecting the vertiacl keel to the margin plates are called().
-
Where are the zinc plates located?()
-
() are mounted on and bolted to the bed-plate cross girders.
-
The gas loads on the engine structure are constrained by means of hydraulically preloaded () which connect the bed plate, frame sections and cylinder jackets into a single unit.
-
Compared to internal structural plating,the exterior hull plating on a ship is usually().
-
Upon underwater()by divers,there are no apparent()on the bottom plates of the said vessel.
-
The terms ceiling and margin plate are associated with the().
-
When riveted joints occur at the ends of plating they are called().
-
A-frames are mounted on the bed plate and support () and cylinder block.
-
Metal plates that cover the top of the hawsepipe are called().
-
To reduce the number of strakes at the bow,two strakes are tapered and joined at their ends by a single plate. This plate is known as a().
-
The type of joint formed when a third small plate is riveted over two plates butted together is called a().
-
If the voltage between the plates of a parallel-plate capacitor is doubled, the capacitance of the capacitor ().
-
The 1 plates of the Earth are formed from _______.