Which of the valves listed should be used either in the fully opened or the fully closed position?（）

相似题目

• Which of the listed effects represents the purpose of heat treating steel?（）

  A . Develop ductility B . Improve machining qualities C . Relieves stresses D . All of the above

  查看最佳答案

• Which of the following methods is used to prevent throttling of compressed air through the diesel engine air starting valves?（）

  A . Holding the valve open for a long period B . Increasing the starting air pressure used C . Opening the stating air valve quickly D . Reducing the starting air valve size

  查看最佳答案

• Which of the problems listed represents the major difficulty encountered with thermal expansion valve operation?（）

  A . Lube oil passing through the system B . Moisture or foreign matter collecting at the valve seat and orifice C . Variable spring tension caused by the changing temperature D . Frost on the liquid line

  查看最佳答案

• Which of the listed statements is correct concerning refrigeration systems?（）

  A . Dehydrators must be used continuously in a refrigeration system B . A 25 ton refrigeration system has the same cooling effect as melting 25 tons of ice in 24 hours C . A thermostatic expansion valve is used to control refrigerated space temperature D . The liquid receiver functions to collect and remove non- condensable gase

  查看最佳答案

• Which of the following statements concerning butterfly valves is correct?（）

  A . Special tools are required for lapping or grinding B . It is impossible to throttle flow with a butterfly valve C . To close the valve, it is only necessary to turn the handle a quarter of a turn D . The butterfly valve should never be used in a freshwater system

  查看最佳答案

• Which of the listed classes of fire would most likely occur in the engine room of a vessel?（）

  A . Classes A and B B . Classes B and C C . Classes C and D D . Classes A and D

  查看最佳答案

• Which of the listed pressure control valves would be used to establish the maximum operating pressure of a hydraulic system?（）

  A . Pressure-reducing valve B . Unloading valve C . Counterbalance valve D . Pressure-relief valve

  查看最佳答案

• Which one of following statement is not true concerning the suitable sites of the direct acting relief valve and the pilot operated relieve valve?（）

  A . the direct acting relief valve is used for controlling lower flows and pressure B . the pilot operated relief valve is used for controlling higher flows and pressure C . the pilot operated relief valve is used for controlling lower flows and pressure D . the controlling accuracy of direct acting relief valve is worse than that of the pilot operated relief valve

  查看最佳答案

• Which of the listed refrigeration system components keeps the refrigerant circulating through the system?（）

  A . Expansion valve B . Condenser C . Evaporator D . Compressor

  查看最佳答案

• Which of the listed items should be secured before performing any maintenance on a solenoid operated air start valve?（）

  A . Electric power and starting air B . Lube oil standby pump and control air C . Hydraulic switch and engage jacking gear D . Motor drain and pneumatic control system power

  查看最佳答案

• Which of the fuel injection systems listed uses a spring loaded differential spray needle valve and individual pump for each cylinder?（）

  A . Common-rail injection B . Air injection C . Jerk pump injection D . Distribution injectio

  查看最佳答案

• Which of the processes listed consumes the greatest amount of power while producing the greatest amount of heat?（）

  A . Overcoming sliding friction B . Overcoming rolling friction C . Overcoming fluid friction D . Overcoming oil wedge frictio

  查看最佳答案

• Which of the petroleum products listed has the lowest flash point?（）

  A . Hydraulic oil B . Lubricating oil C . Diesel oil D . Refrigeration oil

  查看最佳答案

• Which of the following are characteristics of named access lists?（）

  A . Individual statements in a named access list may be deleted. B . They require a numbered range from 1000 to 1099. C . When created, they must be specified as standard or extended. D . They are created with the ip access-list command. E . The entire access list must be deleted before editing. F . They are applied with the ip name-group command.

  查看最佳答案

• Which of the listed statements is correct concerning the starting of centrifugal pumps?（）

  A . They should always be started with the discharge valve closed B . They should always be started with the discharge valve opened C . A priming pump is always required to flood the impeller suction D . They should always be started with the sealing line valves closed

  查看最佳答案

• In which of the listed hydraulic systems will the installation of an oil cooler be necessary?（）

  A . Constant tension mooring winch system B . Hatch cover system C . Watertight door system D . Internal combustion engine hydraulic starter system

  查看最佳答案

• Which of the listed bearing types is an example of a solid bearing?（）

  A . Piston wrist pin bushing B . turbine bearing C . Spring bearing D . Diesel engine main bearing

  查看最佳答案

• In which of the listed refrigeration system components does superheating of the refrigerant take place?（）

  A . Expansion valve B . Evaporator C . Drier D . Receiver

  查看最佳答案

• Which of the listed statements is a characteristic of the liquid charged power element used with thermostatic expansion valves?（）

  A . At the designed operating temperature, the liquid refrigerant charge has changed to a vapor B . The liquid refrigerant tends to collect at the bellows or diaphragm and reduces the valve sensitivity C . The sensing bulb is empty of liquid refrigerant charge at the designed operating temperature D . The sensing bulb is never emptied of liquid refrigerant under normal operating conditio

  查看最佳答案

• Using the LIST command in Recovery Manager (RMAN), which two pieces of information in the RMANrepository can be listed?（）

  A . stored scripts in the recovery catalog B . backups that can be deleted from disk C . backup sets and image copies are obsolete D . backups that do not have the AVAILABLE status in the RMAN repository RMAN

  查看最佳答案

• If you increase the clearance between a valve stem and rocker arm, which of the listed condition will occur?（）

  A . valve will open later B . valves will close later C . amount of fuel injected will be increased D . amount of fuel injected will be decreased

  查看最佳答案

• Which of the following is the correct command to list the filesystems in datavg?（）

  A . lsvg -p datavg B . lsvg -l datavg C . lsvg -L datavg D . lsvg -o datavg

  查看最佳答案

• Which of the devices listed is common to all types of pumps?（）

  A . A power end and fluid end B . A propeller and educator C . A volute and impeller D . A turbine and pisto

  查看最佳答案

• Which of the following answer choices are correct characteristics of named access list?（）

  A . You can delete individual statements in a named access list B . Named access lists require a numbered range from 1000 to 1099. C . Named access lists must be specified as standard or extended. D . You can use the ip access-list command to create named access lists. E . You cannot delete individual statements in a named access list. F . You can use the ip name-group command to apply named access lists.

  查看最佳答案