During repair,lubrication lines and orifices must be （）.

相似题目

• This used piston had been tested and approved as a spare part by the （） during last annual repair.

  A . agent B . shipchandler C . surveyor D . engineer

  查看最佳答案

• Water lubricated tailshaft bearings wear,（）

  A . the after one is more than forward one B . the forward one is more than after one C . the forward one is the same with after one D . it depends on the type of engine

  查看最佳答案

• During the deck repair,（） should be measured firstly before tail shaft is drawn out.

  A . the sinking of tail shaft B . the clearance of stern bearing C . the total flexure of both end bearing D . main engine crankshaft deflectio

  查看最佳答案

• 英译汉：lubrication

  查看最佳答案

• Air line lubricators are used in compressed air systems to lubricate （）.

  A、the suction and discharge valves B、tools and equipment served by compressed air C、air line reducing valves D、all of the above

  查看最佳答案

• 切除修复（excision repair）

  查看最佳答案

• The （） of the lubricant should be sufficient to hold the film together, but it should allow the lubricant to flow easily.

  A . specific gravity B . viscosity C . acid value D . calorific value

  查看最佳答案

• 列检所 vehicle repair place

  查看最佳答案

• We have just repaired the motorRemember （） to it during your watch.

  A . to pay attention B . paying attention C . pay attention D . your paying attentio

  查看最佳答案

• During the dock repair, each sea valve must be disassembled, cleaned and ground well.Before it reassemble the sealing surface between the valve and the valve seat should be checked by （）

  A . chief engineer B . surveyor C . the engineer D . the technique personnel of the shipyard

  查看最佳答案

• 直接修复（direct repair）

  查看最佳答案

• 修复(repair)

  查看最佳答案

• （）during the last repair?

  A . Did you have No.4 cylinder repair B . Do you have No.4 cylinder repaired C . Didn’t you have No.4 cylinder repairing D . Didn’t you have No.4 cylinder repaired

  查看最佳答案

• During the dock repair, should be measured firstly before tail shaft drawn out（）

  A . the sinking of tail shaft B . the clearance of stern bearing C . the total flexure of shaft D . main engine crankshaft deflectio

  查看最佳答案

• The cylinder oil is pumped into the cylinder (via non-return valves) when the piston rings pass the lubricating orifices during （）

  A . the upward stroke B . the downward stroke C . the power stroke D . the suction stroke

  查看最佳答案

• 错配修复（mismatch repair）

  查看最佳答案

• Lubricating oil systems for diesel engine journal bearings are usually lubricated by which of the following types of lubricating oil systems?（）

  A . Splash B . Gravity C . Pressure D . Bypa

  查看最佳答案

• There is a （） system lubricating the running gear and cooling the piston and sometimes lubricating the cylinders.

  A . recirculating B . total loss C . cooling D . refrigeratio

  查看最佳答案

• SOS repair

  查看最佳答案

• （）, where minor repairs are carried out with a ship service, often during a stay in portThis may be remote from a ship repair site.

  A . voyage repairs B . routine docking C . damage repairs D . conversio

  查看最佳答案

• During the dock repair, each sea valve must be disassembled, cleaned and ground wellBefore it reassemble the sealing surface between the valve and the valve seat should be checked by ____.

  A.chief engineer B.surveyor C.the engineer D.the technique personnel of the shipyard

  查看最佳答案

• Is this the recorder you want________? A．to have repaired B．to repair it C．to have it repaired D．it repaired

  查看最佳答案

• View the Exhibit to examine the error during the database startup.You open an RMAN session for the database instance. To repair the failure, you executed the following as the first command in the RMAN session:RMAN＞ REPAIR FAILURE;Which statement describes the consequence of the command？（）

  <img src='https://img2.soutiyun.com/ask/uploadfile/2019-03-27/31f166c0cedddf6946f2b336e2153075.jpg' /> A. The command performs the recovery and closes the failures. B. The command only displays the advice and the RMAN script required for repair. C. The command produces an error because the ADVISE FAILURE command has not been executed before the REPAIR FAILURE command. D. The command executes the RMAN script to repair the failure and removes the entry from the Automatic Diagnostic Repository (ADR).

  查看最佳答案

• The key functions of lubricants include （).

  A. reduce friction B. carry away contaminants and debris C. prevent corrosion and seal for gases D. all of the above

  查看最佳答案