Router R1 exists in an Enterprise that uses EIGRP as its routing protocol. The show ip route command output on router R1 lists the following phrase: "Gateway of last resort is 1.1.1.1 to network 2.0.0.0".Whic h of the following is most likely to have caused this output to occur on R1？（）
相似题目
-
By night，you sight the lights of a vessel engaged in underwater operations. If an obstruction exists on the port side of the vessel，it will be marked by（）.
-
When an IPv6 enabled host boots, it sends a router solicitation (RS) message. An IPv6 router responds with a router advertisement (RA). Which two items are c ontained in the RA?（）
-
A new router is added to an existing HSRP standby group. One of the existing routers is in anactive state， the other is in a standby state. Under what circumstance will the new router becomethe active router？（）
-
Which IS - IS router is equivalent to an ABR in OSPF?（）
-
The following routes exist in the Testking router（）
-
HSRP is being set up between two Company devices. In what three states is it possible for an HSRP router to be in？（）
-
Router R1, an ASBR connected to the Internet and to backbone area 0, has been configured with a default - information originate command. Which of the following is true about the effects of this configuration command?（）
-
Which series of commands will configure router R1 for LAN-to-LAN communication with router R2？ The enterprise network address is 192.1.1.0/24 and the routing protocol in use is RIP.（）https://assets.asklib.com/images/image2/2018072315342863428.jpg
-
As an experienced technician, you are responsible for Technical Support in your company. You ask one of the trainees to document the layers of an existing CIS network. Which three statements best characterize this process? （）(Choose three.)
-
The following output exists on Router R1, a router internal to area 1. What can you d etermine as true from the output of the show ip ospf database summary command?（）https://assets.asklib.com/images/image2/2018073109431965617.png
-
Which three functions can an Integrated Services Router perform in a VoIP network？（）
-
What bit should be set in the link state PDUs in an IS-IS level-1-2 router to indicate that they are a potentialexit point out of the area ？（）
-
In order to enable remote administration of users and tablespaces on an Oracle database, which of the following types of files must exist in the database?（）
-
As an experienced Network Engineer, you are required to characterize an existing CIS network. In such a situation, what is the last step to take?（）
-
Router R1, in ASN 11, learns a BGP route from BGP peer R22 in ASN 22. R1 and then uses BGP to advertise the route to R2, also in ASN 11. What ASNs would you see in the BGP table on R2 for this route?（）
-
Router R1 has been conf igured with an ipv6 route 2000::/64 S0/0/0 64 command.Which of the following does the 64 at the end of the command represent?（）
-
A System p administrator in a manufacturing customer plans to migrate an AIX 5.2 system to a new LPAR on an existing System p using VIOS. Which of the following must be completed prior to this migration （）
-
An administrator believes that the Staging Configuration Directory （SCD） may be locked due to an error in aDARE event. Which of the following commands can the administrator run to check for the existence of locks？（）
-
It is 1666 in the Bay Colony, and an uneasy truce exists between local and their neighbours, the . Hester Prynne arrives here overseas from England.
-
Router R1 has the following configuration. Assuming R1‘s F0/0 interface has a MAC address of 0200.0011.1111, what IPv6 addresses will R1 list for interface F0/0 in the output of the show ipv6 interface brief command？（）interface f0/0ipv6 address 2345:0:0:8::1/64
-
Refer to the exhibit. EIGRP is configured with the default configuration on all routers. Auto summariz ation is enabled on routers R2 and R3, but it is disabled on router R1.Which two EIGRP routes will be seen in the routing table of router R3？（）
-
Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exists in a planning document, intended to be used to copy/paste into Router R1 to enable OSPFv3 on interfaces F0/0 and S0/0/0. No other related configuration exists. Assuming F0/0 and S0/0/0 reach an up/up state, which of the following is true about OSPFv3 on R1 after this configuration has been pasted into R1？（）ipv6 router ospf 1ipv6 unicast- routinginterface f0/0ipv6 address 2000 ::1/64ipv6 ospf 1 area 1interface s0/0/0ipv6 address 2001::/64 eui - 64ipv6 ospf 1 area 0
-
There are three IS-IS routers on a Gigabit Ethernet segment: Router A, Router B, and Router C. Each router is configured in the same area and each routers Gigabit Ethernet interface is configured for Level 1-only. Router A is the Designated Intermediate System (DIS). Each routers IP address on that segment is:Router A: 10.1.1.1/24Router B: 10.1.1.2/24Router C: 10.2.2.1/26Which statement is true about all the adjacencies that exist on that LAN？（）
-
The records （） to show an improvement in sales thatdidn’t exist.